hager JKD201SPD Surge Protection Kit Instruction Manual
- June 3, 2024
- hager
Table of Contents
hager JKD201SPD Surge Protection Kit
Parts list
- 16mm sq neutral cable
- 16mm sq L1/L2/L3 cable
- 4 x M5 Hex HT Screws
- 1 x Type II SPD sub assembly
Surge Protection Kit JKD 250A Type I+II
- Screw the surge protection sub-assembly on the right hand side of the enclosure as shown using the 4 off Hex head High Torque screw to the chassis at 5Nm
- Connect the L1/L2/L3 cable lugs to the Incomer using the existing incomer bolts provided, torque to 13Nm and connect the Neutral cable to the neutral bar to the left of the MCCB, then terminate into the relevent terminals on the SPD
ABOUT
- The device may only be connected and installed by an electrically skilled person. National standards and safety regulations must be observed.
- The device must be checked for external damage prior to installation. If any damage or other defects are detected in this check, the device must not be installed.
- Its use is only permitted within the limits shown and stated in the installation instructions.
- Opening or otherwise tampering with the device invalidates the warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>