Wet Sounds TB-MIC Talk Back Microphone With Adjustable Mic Gain User Guide
- June 13, 2024
- wet sounds
Table of Contents
Wet Sounds TB-MIC Talk Back Microphone With Adjustable Mic Gain User Guide
Connections
Installation
You will need to remove 4 Allen screws to gainaccess behind the radio. You
willhave room on both sides of the MC-2.
Wipe area with alcohol let dry then apply double side tape to the Talk Back
Mic. mount the unit on the left-hand side add some foam padding to prevent
rattle.
Once you have the box secured then time to wire into the MC-2’s harness. Wire
up Blue to Blue and then extend your power and ground to go towards the back
with the Aux Cables.
In order to reach the glove box area or just anywhere up front you will need
to purchase two 25ft Aux Cables to make the run.
The Fuse box is in the same area as the secondary amp. There is a 12v output
location available. remove cover and place a 2amp fuse in the empty location.
And connect your red wire from the talk back mic and ground at any ground post
Plug in your 3.5 Aux cables and tape/heat shrink and rout them towards the
back of the roof with a Long zip Tie or a wire grabber. removing the Secondary
amp will make things easier to fish the cables through.
With the amp out you will pull the grommet out some and will need to cut the
electrical tape in order to slide the cables into the main harness of the
roof. You will tuck the cables in till you get down to the area were its
connected to the batter
Wrapp the aux cables in tesa tape to make the run easier. There are a few tabs you will need to remove from the cupholder panel. This will allow you to run the cables up front following OEM wires.
Once the rear center console is removed you can run the Aux cables along side OEM wire.
Lift passenger sear and remove tray to gain access and pull the AUX cable from the back.
There is an OEM harness that you can zip tie and run the cables along side it.
Now the front cup holder/center console needs to be removed same process as the rear one.
The center switch panel will need to be removed to gain access to the glove
box.
Under the switch panel you will locate 2 tabs to be removed.
Route your cable along side of OEM harness and up into the dash area. In
order to make your way to the glove box. Any access wire you can tie up in
this area.
Mount the control just shy of the glove box you can and pop 2 holes big enough
for the AUX cable to fit through.
The male Aux will go to the controller and the female Aux will go to the Mic.
The Mic will reach to the driver area andcan still close the glove box. We
recommend this location to prevent loss or damage when not in use.
WET SOUNDS, INC.
2975 LOUISE ST
ROSENBERG, TX 77471
TOLLFREE 877-938-7757
FAX 832-550-2331
Documents / Resources
| Wet
Sounds TB-MIC Talk Back Microphone With Adjustable Mic
Gain
[pdf] User Guide
TB-MIC Talk Back Microphone With Adjustable Mic Gain, TB-MIC, Talk Back
Microphone With Adjustable Mic Gain, Microphone With Adjustable Mic Gain, With
Adjustable Mic Gain, Adjustable Mic Gain, Mic Gain
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>