Faylor Fl-A23 Sonic Electric Toothbrush User Manual

Faylor Fl-A23 Sonic Electric Toothbrush

SAFETY TIPS

Prohibition!

• Don’t charge in the bathroom! Don’t place the charger above or near water container (such as tub pool, etc).
• Battery can not be replaced by yourself, can only replaced by authorized maintenance center. Manufacturer takes no responsibility for any accidents during replacement by users themself . See page 13 in case of special reasons to be required to remove by self.
• In order to avoid danger, once the power cord damages, please stop use this product at once.

caution!
To ensure safety, 8-12 years old children, mental disorders and disabilities must be supervised or guided when they using this product\

Attention!

• It is a normal phenomenon to feel stimulation when using this product at the first time. Please stop using this product and consult your dentist if feeling continuous stimulation in two weeks.
• Please stop using this product and contact your dentist if feeling pain when using it.
• It is normal that the main body is a little warm when charging, please cut off power supply when feeling very hot, and check it in the customer service cen ter.
• All the product accessories should be used our corresponding accessories, like charger, brush head,charging line and adaptor which pass certification required in this country.
• The product is just only designed to clean your teeth, gum and tongue. Please do not use it for any other purposes. This product is for personal product, not for the use of dental clinics or institutions.
• People who just had the oral or periodontal surgery, or are under the treatment within two months.or there are other symptoms(including people whose dentures are week or gums are massively bleeding, etc.) ,or crowds whose oral is sensitive and vulnerable, please stop to use the product and consult your dentist.
• The toothbrush should only be used at room temperature and should not be exposed to the sun. It should be kept in airy place.
• Please cut off the power of charger when not charging ,unplug from socket before . Please do not clean toothbrush head, toothbrush holder, charger, charging line with disinfector in the dishwasher, washing machine and ultrasonic cleaner. See page 11 for details of cleaning & care.
• Please don’t leak the gelatin, oil, glue or stimulation chemical liquids on the product surface.
• Regularly clean power plug, preventing dust and dirt accumulation.
• The suggested lifespan should be 2 years. Please don’t use over 2 years.You should take out the battery form toothbrush before scrapped.If you want to learn how to dismantle battery please refer to Environmental Protection&Recycle at page 13.
• When the power is on, the charger should not be in direct contact with or near metal objects.such as keys, coins, cell phone cases, metal caps, etc. The metal body can cause abnormality of wireless inductive charger or even damage the charger

FITTING

Please carefully check the fitting and its number

OPERATOR PANEL INSTRUCTION

• On/Off button Short press once to start work, Adjust the strength with a short press, Press and hold the On/Off button to turn off.
• Charge indication function {charging status) The strength indicator bar is flickering when charging.The strength indicator bar is fully lit when full charged.
• Low Battery Indication The strength indicator flashes 6 times quickly, and the body shakes 6 times at the same time, which indicates that the battery is low and needs to be charged in time.When the battery voltage is lower than 3.0V, the strength indicator flashes 3 times quickly, and it will automatically shut down immediately.
• In the charging state, you can not turn on the vdevice by press On/Off button

FUNCTION DESCRIPTION

ON/OFF Button
Press the On/Off button to turn on the toothbrush. After turning on the toothbrush, it automatically enters the mode that was memorized during the last shutdown. The vibration strength is the strongest by default. The user can adjust the vibration strength as required. Press and hold the On/Off button to shut down.

Vibration Adjustment
After turning on the toothbrush, choose the nnappropriate vibration intensity according to personal needs. When the appropriate vibration intensity is selected, the indicator light is always on. During use, the user can switch other vibration intensity at any time. Single-click the On/Off to jump to the next vibration intensity, which can be unlimited. Once vibration intensity selected and you can enter the brushing experience.

Smart Reminder
For dental and oral health, dentists recommend brushing for 2 minutes each time. There is a reminder to change your position every 30 seconds. A pause during brushing reminds you that you need to change direction ( for details, see page 8).

Intelligent Memory
Select the appropriate vibration strength according to your personal settings. When you turn it on again, the toothbrush will remember the mode you used last time and start your brushing experience directly.

Vibration Strength Function

Weak Vibration Strength
The strength indicator is at the shortest position, and the brushing strength is the weakest-28,000 vibrations p er minute, which is suitable for first-time use or children’s use.

Strongest Vibration Strength
The strength indicator is at the longest position, and the brushing strength is the strongest-38,000 vibrations per minute, which is suitable for people who have used electric toothbrushes for a long time.

Intermediate Vibration Strength
The strength indicator is between the strongest and the weakest. The brushing strength can be adjusted according to personal needs

TOOTH-BRUSHING&TIMING

• We suggest brushing your teeth twice a day and 2 minutes for each time.
• You will feel a temporary stop every 30 seconds during use. This aims to reminding you that this part has achieved its best cleaning effect.you need change brush area( Suggest brushing C as showed above)
  • Lateral teeth upper left & lower left
  • Inside teeth upper left & lower left
  • Inside teeth upper right & lower right
  • Lateral teeth upper right & lower right

INSTALL & USE

1. Put the head into the output axle carefully.Leave a space between the head and the main body, which is necessary for the vibration of the head. Try to start and test the toothbrush if working properly.
2. Put a little toothpaste on the head. Please don’t tum on the toothbrush to prevent toothpaste from splattering
3. Wet the head and toothpaste before brushing your teeth, which will allow the toothpaste to be more fully decomposed when brushing your teeth
4. Brush softly. Don’t press too much, otherwise it will hurt gum and teeth surface. Move toothbrush head slowly, back and forth
5. Don’t forcefully press teeth when brushing.
6. Rinse your mouth with water after brushing

CHARGING INSTRUCTION

• Please start your toothbrush first when initial use, if you find the toothbrush is in the low power or no power situation, please make sure your toothbrush fully charged before use.

• Without operation longer than 6 months, please charge your toothbrush fully according to the charging instruction(shown in the right pictures)

• While using your toothbrush, if charging lamp keeps flashing and your toothbrush don’t shakes .. Your toothbrush is in shortage of power. Please recharge in time.

• Please put toothbrush body on the charger and confirm that the charger has safely powered on.

• It indicates under the charging when the charge lamp keep red after putting the main body in charging base.And it indicates fully charged when the indicator light keep green flash

• Before using it for the first time, please start the toothbrush first. If it is in low or no power state, please use it after being fully charged. If you have not used it for more than 6 months, please charge it first according to the requirements of the toothbrush model until it is fully charged. See charging indication chart for charging.

• During the use, if the strength indicator flashes continuously and quickly, it means that the toothbrush has insufficient power, please charge it in time.

• Please insert the charging cable into the charging hole at the bottom of the main body, and confirm that the power is safely connected. The toothbrush strength indicator shows flickering, indicating that charging is in progress. When the indicator is on, it means it is full.

• If it has not been charged for a long time, the indicator light will not light up when charging again, and it will light up after 6-10 minutes, which is normal.
  Note : Charging in accordance with the instructions can also guarantee the life of the product.

• The charging icon

CLEAN & MAINTENANCE

Regular cleaning will maintain the best condition of the product and lengthen its service lifetime

TO CLEAN THE BRUSH HEAD
Please clean the toothbrush head after every use, let it dry naturally. Do not press and pull hard the bristle to avoid deformation and falling off.

TO CLEAN THE MAIN BODY
Clean your toothbrush with soft cloth and let it air drying. Do not immerse it in water for long time.Do not clean with hot water or acid. Cleaning solution: Suggest to use medical alcohol cleaning.

TO REPLACE THE BRUSH HEAD
We suggest you change the head of your toothbrush every three months.

ENVIRONMENTAL PROTECTION &RECYCLE

• FL-A23 sonic toothbrush with a built-in rechargeable battery contains substances, which may pollute the environment. Please don’t put this dumped toothbrush together with life garbage, need take out the battery and put it into recycling barrel. Our product should be delivered to corresponding recycling center, which is conductive to environmental protection. If you have any difficulties about taking out battery, you can send the product to our maintenance center.
• If you intend to disassemble your product, please comply with the following procedures, and send all finished parts and battery to recycling center designated
• According to the following steps, the operation shall comply with the basic safety precautions. Be sure to protect your eyes, hands and workbench surface.
• Remove toothbrush head from the main body, turning on the power until the battery is completely exhausted.
• Put the suitable crosshead(standard) screwdriver into the slot located at the base of the toothbrush holder.
• Put the handle of your toothbrush on a hard surface with buttons upward, carefully open the enclosure from bottom edge with slot type screwdriver(standard), until the enclosure is 2.5 cm away the bed.
• The slotted screwdriver(standard) will be used to pry out the elastic buckle, meanwhile, pushing down the toothbrush shell, and taking out the inner component of the toothbrush.
• The slotted screwdriver(standard) will be inserted into plastic box to pry out the battery.

FAULT DIGNOSIS

SPECIFICATION

• Name of the product : Sonic Toothbrush
• Model Number : FL-A 23 Parame t ers
• Rated voltage : DC3.7V
• Rated power : 1 . 7W
• Input voltage : DC5.0V
• Place of Production: Shenzhen City, Guangdong Province.China

Note : Please read the specifications carefully for accurate use.

Your purchase from Faylor is guaranteed Email us with your order ID, we will respond within 24 hours.  support@ifaylor.com If you found our product defective, please contact us in the first time. We will deal with your problems carefully and quickly

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>