CareCo BD03030006 Bed Rail with Floor Support Instructions

Usage and Maintenance Instructions

Accenture Bed Rail with Floor Support – BD03030006

You should have these parts:

End Bar xl                                       T- Bar x2

Extension Bar – Back x2                  Extension Bar – Front x2

Straps xl                Legs x2                               Handle Bar xl

Verify all parts are included before assembly.

Instructions

1. Extension Bar – Front
2. Extension Bar – Back

1. Insert Extension Bar-Front into Extension Bar-Back and hand-tighten the threaded connectors. Set aside.

1. T- Bar
2. Handle Bar

2. Insert T-Bars into each side of the Handle Bar. You may need to loosen the ridged clamps a little and tighten after inserting the Handle Bar.

Lay the assembled part on a flat surface.

1. T- Bar
2. Arm Extension

3. Take the assembled Extension Bars and insert the larger diameter into the T-Bar horizontally.

1. End Bar
2. Arm Extension

4. Take the End Bar and insert it into the end of the Extension Bar assembly.

5. Insert the Legs into the T-Bar and adjust to the required height using the push-pin buttons.

1. T- Bar
2. Legs

6. Adjust the length of the Extension Bars as needed and tighten all threaded connectors. Place the strap around the mattress and fasten.

Warning!
Before use, check that all push-pin buttons fully protrude through the holes where the bars are joined.
Ensure both legs touch the floor and that the hand grip is steady before using.

www.careco.co.uk                    1 Turing Court, Great Notley, Braintree, CM77 7AT, England

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>