litter-robot 4 OdorTrap Holder Installation Guide
- June 13, 2024
- Litter-Robot
Table of Contents
litter-robot 4 OdorTrap Holder
INSTALLATION
- Make sure the unit is in the Home/Ready position. Press and hold the Cycle and Empty buttons on the Litter-Robot 4 control panel for 3 seconds, or tap “Replace Filter· under Controls in the Whisker app.
- A clean cycle will begin. The cycle will pause when the globe reaches the position where customers are able to access the filter pocket.
- Open the bonnet: Press and hold the latches on both sides of the bonnet, then lift and rotate the bonnet to its open position to reveal the filter pocket.
- Remove the filter cover: Lift the small notch to release the filter cover snaps from the globe. Set aside the filter cover.
- Remove the carbon filter (if installed) and prepare to install the OdorTrap® Holder.
- Open the Odor Trap® Holder by unsnapping the two (2) side clips.
- Place the opened Odor Trap® Holder on the filter cover. The centre arrow on the OdorTrap® Holder must line up with the small dot on the centre of the filter cover.
- Flip the filter cover over and snap the two outer pieces of the Odor Trap® Holder into the filter cover. Then snap the two inner pieces of the Odor Trap® Holder into the filter cover.
- Place up to (3) Odor Trap• Packs inside the OdorTrap• Holder.
- Secure the Odor Trap® Packs by closing the Odor Trap® Holder (snap the side clips closed).
- Replace the filter cover in the filter pocket on the globe with the OdorTrap® Holder facing down. Make sure the filter cover is completely flush with the globe to prevent obstruction while the globe rotates.
- Close the bonnet: Rotate the bonnet downward over the globe and push down on the bonnet from the top to make sure it is latched and secure.
- Press the Cycle or Reset button to resume the clean cycle; when the clean cycle has ended, press the Reset button to zero the weight sensors.
Using the Odor Trap® Holder, Litter-Robot 4 can be equipped with up to (3) OdorTrap® Packs that are installed on the outer bottom area of the globe. The packs sit directly over the waste drawer to eliminate odours . (Odor Trap® Packs are sold separately and not required for the unit to function. We recommend replacing Odor Trap® Packs every 2-4 weeks for optimal performance.)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>