MICROTECH 1105500251 Cable Crimping Digital Micrometer User Manual
- June 13, 2024
- microtech
Table of Contents
MICROTECH 1105500251 Cable Crimping Digital Micrometer
SPECIFICATION
Item No
| Range| Resolution| Accuracy| Micrometer head|
Anvils types| Protection
---|---|---|---|---|---|---
| mm| inch| mm|
μm
| | |
1105500251| 0-20| 0-0.8”| 0,001| ±4| Friction rotating| Point & Blade
0.75×6.5|
IP-65
FUNCTION
OPERATION
-
Clean the oil from the measuring surfaces of micrometer by cloth.
-
If necessary, open the battery cover; insert the battery (type CR2032) according to the polarity of the electrodes. Blinking display information or absence suggests replacing battery. After battery replacement on the screen will be ———- indication. Press SET button for setting 0.000 .
-
Turn on the display by pressing 0/MODE button.
-
Check the setting display to zero. Contact with each other (or with setting gauge) measuring surfaces of the anvil and the spindle, using the ratchet and take a measurement.
Rotation the micrometer screw in the direction of convergence measuring surfaces using the ratchet. ip located at the end of screws, used only for reverse spindle. -
For zero setting, press the O/MODE or SET button and hold it to reset to Zero.
-
After switching on, the display shows the measured value of the metric/ English system of units. Press UNIT button to switch between metric/ English measurement systems.
-
After switching on, the display shows in absolute or relative terms. Press O/MODE button to switch between absolute and relative measurement
-
During measure, thimble should rotate only by ratchet. Ensure contact of workpiece with measuring surfaces of the micrometer so tightly to ratchet cranked 2-3 times. Try to prevent warping measuring surfaces.
-
This micrometer has auto switch off function (10 min non using) ot press UNIT button during 2 sec. to switch off.
-
After work the measuring surfaces of the micrometer wipe with a cloth and apply ant corrosive oil.
WARNING !
-
Avoid contact with the body electronics unit micrometer emulsions and oils.
-
During the measurements, periodically check the zero setting micrometer.
-
Do not make the rotation of the micrometer screw in close measuring surfaces using a thimble.
-
Avoid shocks or falling, even with a small height.
-
Do not disassemble or adjust the micrometer persons who unrelated to the repair.
CUSTOMERS SUPPORT
MICROTECH
innovative measuring instruments
61001, Kharkiv, Ukraine, str. Rustaveli, 39
tel.: +38 (057) 739-03-50
www.microtech.ua
tool@microtech.ua
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>