MICROTECH ZMC3 Auto Lock Car Mount User Manual
- June 5, 2024
- microtech
Table of Contents
MICROTECH ZMC3 Auto Lock Car Mount
INTRODUCTION
Auto Clamping Dashboard Mount is the last mount you’ll need to purchase. The sleek black design ensures that it matches with every dashboard and car environment it is put into. It can bend in all different types of directions so you could place it and use it however you would like. The suction cup doesn’t only suck the product to the dashboard or windshield but it also has a sticky like adhesive on it that way there is no possible chance it could fall or tip over in the middle of your journey.
PACKAGE CONTENTS
- 1x Clamp and Release Phone Holder
- 1x Socket
- 1x Back connector
- 1x Suction Cup Stand
PRODUCT OVERVIEW
SPECIFICATIONS & FEATURES
- Mount Body is 6 cmx 10.5 cm with a 3.5 cm depth
- Adjustable clamp can go from 5.5 cm to 8.5 cm
- The wings expand to 10.5 cm
- Stand is normally 14.5 cm tall
- It can extend in height to 19.5 cm
- The suction cup is 6.5 in diameter
- The phone holder foot is 1 cm wise
- Strong and secure suction cup to stick to any flat surface
- Tight fitting clamp with rubber grips
- Quick-Use Spring loaded clamping mechanism
- Extendable Arm for optimal viewing angle 360 rotating phone bracket
- Easy Installation
- Sticky suction cup Can adhere to windshield or dashboard
HOW TO USE
Constructing the Mount
- Unbox all pieces and make sure you have everything
- Take flat piece and connect pieces into holes on the back of mount and then slide up to secure
- Screw joint part onto the back of the mount body but loosely
- Leaving it loose will allow for the ball to pop in easily
- Once the ball is in socket, tighten knob to make sure its tight
- Take plastic peel off of suction cup
- Place mount on dashboard or windshield in desire location
- Squeeze the wings in to expand the clamp
- Put phone in clamp and press it towards the back of the mount to close the clamps and tighten in
- Pull down lever on the bottom of the stand to make sure that the suction is extra secure
- Squeeze wings aqain to release phone
CARE AND SAFETY
- Do not use this unit for anything other than its intended use.
- Keep the unit away from heat source, direct sunlight, humidity, water or any other liquid.
- Do not expose the device to extremely high or low temperatures, as it may damage the battery.
- Do not operate the unit if it has been wet or moist to prevent against electric shock and/or injury to yourself and damage to the unit.
- Do not use the unit if it has been dropped or damaged in any way.
- Repairs to electrical equipment should only be performed bya qualified electrician. Improper repairs may place the user at serious risk.
- Keep the unit out of reach of children.
- This unit is not a toy.
BATTERY DISPOSAL:
This product contains a lithium polymer battery. Lithium polymer batteries are
environmentally safe when fully discharged. Please refer to your local and
state laws for battery disposal procedures. OSMTEK GROUP INC, All rights
reserved.
MicroTech is a trademark of SM TEK GROUP INC.
All trade names are the registered trademarks of the manufactures listed. New
York, NY 10001 www.smtekgroup.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>