ComXim MT320RL40 Electric Turntable Instructions
- June 13, 2024
- ComXim
Table of Contents
ComXim intelligent turntable instruction
Used for product rotation display
360 degree shooting
3D scanning
MT320RL40 Electric turntable operating manual
- Plug in power supply and turn on the turntable.
- Use the remote control to control the rotation modes, rotation speeds and rotation angles.)
- This Series of electric turntables support 3 rotation modes: continuous, intermittent and left-and-right swing.
Product parameters
Item No. | Voltage | Speed(S/Lap) | Max Load(Kg) |
---|---|---|---|
MT200RL20x | 100V – 240vAC | 20-68(S/Lap) | 20 Kg |
MT320RL40x | 100V – 240vAC | 25-72(S/Lap) | 40 Kg |
MT350RL40x | 100V – 240vAC | 28-74(S/Lap) | 40 Kg |
MT400RL40x | 100V – 240vAC | 27-76(S/Lap) | 40 Kg |
NT400RL40x | 100V – 240vAC | 25-72(S/Lap) | 40 Kg |
MT500RL200x | 100V – 240vAC | 34-90(S/Lap) | 200 Kg |
NT600RL200x | 100V – 240vAC | 34-90 (S/Lap) | 200 Kg |
MT800RL300x | 100V – 240vAC | 55-140(S/Lap) | 300 Kg |
MT Series turntable model maming rules, identification and main
characteristics
MT | 200 | RL | L20 | X |
---|---|---|---|---|
320 | RL | L40 | ||
Series | Turntable | Sub code | Max Load | International |
or color
name| Model| R: Remote control| (Kg)|
| code| | |
| Diameter| | |
| (cm)| | |
Small remote controller instructions
Note: ACR2025 buon baery is used to provide power for the remote controller.
Medium remote controller instructions
Note: AAA baery is used to provide power for the remote controller.
Large remote controller instructions
Note: AAA baery is used to provide power for the remote controller.
Plrecautions
- Attention: Electric turntables are of electric products. They are Not waterproof and not heat resistant.
- In cases when turntable doesn’t work, please check whether the turntable is powered on, whether the power cord is plugged in tightly, and whether the switch is turned on. If the turntable still cannot work normally, please contact us.
- The load-bearing capacity of the turntable refers to the maximum load that the turntable can bear when the item is smaller than the diameter of the turntable. If the item exceeds the diameter of the turntable, the load-bearing capacity will be greatly reduced, and even it will not turn.
- In order to prolong the service life of the turntable, it is recommended to stop for 2 hours after working continuously for 8 hours.
- In order to protect the safety of users, unauthorized modification or repair of the product is prohibited. Please contact us if necessary.
Notes
§ 15.19 Labelling requirements.This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions:(1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
§ 15.21 Information to user.Any Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
§ 15.105 Information to the user.Note: This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and u s e d i n a c c o r d a n c e w i t h t h e i n s t r u c
t i o n s , m a y c a u s e h a r m f u l i n t e r f e r e n c e t o r a d i
o communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: -Reorient or relocate
the receiving antenna.-Increase the separation between the equipment and
receiver.-Connect the equipment into an outlet on a circuit different from that
to which the receiver isconnected. -Consult
the dealer or an experienced radio/TV technician for help.
*RF warning for Mobile device:This equipment complies with FCC radiation exposurelimits set forth for an uncontrolled environment. Thisequipment should be installed and operated withminimum distance 20cm between the radiator & yourbody.
Copyright reserved by Shenzhen ComXim Technologies Co.,Ltd.2023
www.comxim.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>