ELRO HE888 Dimmer Transmitter User Guide
- June 13, 2024
- ELRO
Table of Contents
ELRO HE888 Dimmer Transmitter
Wire Connection
-
Preparation for use
a Turn off the power with the power switch in your meter cupboard. -
Connecting the receiver (HE888) to the power supply
a Connect the phase wire (brown) with Land connect the neutral wire (blue) to N.
-
Connecting the receiver to the lamp
a Connect the black wire of the lamp to and connect the blue wire from the lamp to N.
-
Mounting the receiver
a Screw the receiver to the desired spot (lamp fitting, mounting box or junction box) and switch on the power with the main switch in your meter cupboard. -
Linking the receiver to a transmitter
a The red LED should be burning continuously; now, press and hold the LEARN button for two seconds and then release it.
b During this operation the LED starts to blink. Your receiver is now switched in the linking mode.Attention: the LED should blink only after releasing. If the LED starts blinking during pressing then there will be no linking.
Linking your transmitter to a receiver. Follow the manual of your transmitter. Attention: it is possible to link a receiver to multiple transmitters, six memory positions are available. -
Disconnecting all links
a The red LED should be burning continuously; now, press and hold the LEARN button for six seconds.
b During this operation the LED starts to blink (see Sb).
c Briefly press on the LEARN button. The LED will turn off and then on again, all links are undone.
For the document of conformity go to www.elro.eu or scan the QR code
Specifications
AC Input Voltage: 220V-240V, 50/60Hz.
Maximum distance (meters): 50.
Maximum power (Watts): 200.
Operating temperature: -1 O – 50.
Suitable lamps: incandescent, energy saving bulbs and halogen without
transformer.
Customers Support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>