smartwares SH4-99572 Shutter Curtains Switch Instruction Manual
- June 13, 2024
- smartwares
Table of Contents
smartwares SH4-99572 Shutter Curtains Switch
Instruction manual
PREPARATION BEFORE USE
- Please read the operating instructions!
- Observe the warning and safety notes!
- In your electrical circuit panel, locate the circuit breaker control for the wall switch you will be working on. Switch the circuit off.
CONNECTING THE RECEIVER TO THE POWER SUPPLY
- Connect the phase wire (brown) to L and connect the neutral wire (blue) to N.
Connecting the receiver to the roll-down shutter motor (standard connection)
First consult the instruction manual of the motor before connecting it.
- A. Connect the “UP/OPEN” pin of the motor to B and connect the “DOWN/CLOSE” pin of the motor to A.
- NOTE: For the correct connections of a potential free contact, please consult the instruction manual of the gate or garage door motor.
- B. Connect the phase wire of the motor (black) with C.
INSTALLING THE WIRELLES WALL SWITCH
- A. First remove the push button(s) and the frame from the mounting plate.
- B. Attach the mounting plate to the desired spot on the wall, using the supplied screws. Make sure the “UP” arrow is in the right position (3).
- C. Activate the battery by pulling out the tab (3).
- D. Place the frame back on the mounting plate by using the mounting knobs.
- E. Place the push button(s) back on the mounting plate. Make sure “UP” is in the right position (4).
MOUNTING THE RECEIVER
- Mount the receiver in place of the existing up/down switch and switch on the power with the power switch in your electric circuit panel.
PAIRING
Pairing the receiver with a sender
- A. Press and hold the button on the receiver for 3 seconds, then release it (5). The LED starts to blink. Your receiver is now switched to pairing mode.
- Attention: the LED should only blink after releasing the button. If the LED starts to blink while holding the button, there will be no pairing.
- B. Press the “PAIR” button on the sender for 2 seconds to pair it with a receiver. The LED on the receiver will light up and the LED on the sender will start blinking rapidly.
- Your receiver and sender are now paired.
- Attention: it is possible to pair a receiver with multiple senders, eight memory positions are available.
OPERATING RECEIVERS
- Press the “I/ON” button on the sender to activate the receiver.
- Press the “O/OFF” button on the sender to turn off the receiver.
Disconnecting all links
- A. When the switch is connected to the power supply, press and hold the button on the built-in switch for 6 seconds, then release it.
- B. The LED starts to blink quickly for 12 seconds.
- C. During this period, press the button again, the LED will start to blink slowly, then stops blinking and is constantly lit.
- D. All links will be disconnected.
Specifications
Remote control
- Battery: 3VDC, type CR 2032 (incl.)
- Frequency: 433.92MHz
- Wireless range: 30m
Built-in switch
- Wattage: 300
- Frequency: 433.92MHz
- Wireless range: 30m
- Input: 230V~ – 50Hz
CONTACT
- Jules Verneweg 87
- 5015 BH Tilburg
- The Netherlands
- www.smartwares.eu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>