Simx UT-M1 Ultecon Thermostat Instruction Manual
- June 13, 2024
- Simx
Table of Contents
INSTALLATION INSTRUCTIONS
Ultecon Thermostat UT-M1
Order Code: FAN5856
UT-M1 Ultecon Thermostat
NOTE
- The thermostat requires 220-240V AC to operate.
- In order to correctly adjust the system to room temperature, install the thermostat as far from heat sources, draughts or particularly cold walls (thermal bridges) as possible.
CAUTION
- Before wiring the appliance be sure to turn off the mains power.
- The appliance must be wired to the electric mains through a switch capable of disconnecting voltage as per the current New Zealand safety standards.
- Installation and electrical wiring of this appliance must be made by a qualified technician and in compliance with the current standards.
IMPORTANT
- Isolate the mains supply before making any electrical connections.
- This system should be installed by a qualified electrician.
- Thermostat should only be installed by fixed wiring, a flexible cord should not be used.
- The appliance is not intended for use by young children or infirm persons without supervision.
- Young children should be supervised to ensure that they do not play with the appliance.
Distributed by: Simx Limited
Ph: +64 9 259 1660
Technical Support Ph: +64 9 259 1662
Email: sales@simx.co.nz
www.simx.co.nz
Specifications are subject to change without notice.
PUB0217 2305
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>