Simx Lighting LHT1188 Nova 2000 LED Bulkheads Wall or Ceiling Mount Light Instruction Manual

Simx Lighting LHT1188 Nova 2000 LED Bulkheads Wall or Ceiling Mount Light

Thank you for purchasing the Simx Lighting Nova LED Bulkhead. It requires a 220V-240 AC power supply to operate and should be installed by a registered electrician Please read this manual before installation and retain it for future reference.

IMPORTANT

This product is suitable for use only with a supply voltage of 220-240V AC, 50Hz. All electrical work must be carried out in accordance with local and national electrical codes as applicable. We strongly recommend that this light fitting be installed by a registered electrician. Always switch the power off prior to installation. A means of mains power isolation must be installed in the circuit for the purpose of safe access for any internal cleaning, recalibration, or maintenance. This light fitting is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience
and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Young children should be supervised to ensure that they do not play with the appliance. Any changes or modifications made or attempted to this product, without the prior written approval of the manufacturer, will void any and all stated warranties.

TECHNICAL SPECIFICATIONS

DIMENSIONS (mm)

INSTALLATION

• Pierce central gland to feed incoming supply cable.
• Alternatively, there are 4 side mount locations for surface cabling.
• Drill the side wall at the marked locations and gland conduit to maintain the IP rating. Maximum 20mm diameter hole.
• Mount base to ceiling or wall securely.
• Utilize the mounting hole locations only.
• The supplied rubber gaskets must be used to maintain the IP rating
• when installing and use appropriate screws to suit the gaskets and selected mounting holes.
• Terminate the cabling to match the termination box label.
• Reconnect the cable connector between the driver and the LED array.

MANUFACTURERS EXTENDED WARRANTY

This product is guaranteed by SIMX Ltd and Ventair Pty Ltd for 5 years from the date of purchase against faulty materials or workmanship which affects its designed ability to operate. During this period if the product has a defect of this nature it will be repaired or replaced free of charge by SIMX with the same item, or a similar one of higher specification.

ON CONDITION THAT

• The buyer returns it to the seller from whom it was bought, and freight is paid.
• The product has been bought by the user (ie. a receipt/sales invoice is produced as proof of purchase).
• The product has not been misused or handled carelessly, installed in any way contrary to the installation instructions, or installed in any unusually exposed or harsh environmental conditions.

This guarantee excludes liability for discoloration and/or delamination of paint plastic or any user-serviceable parts. It does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. Our Goods come with guarantees that cannot be excluded under either Australian or New Zealand, Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the Goods repaired or replaced if the Goods fail to be of acceptable quality and the failure does not amount to a major failure.

Distributed in lew ceding oy offa
Ph: +64 9 259 1660
Technical Support Ph: +64 9 259 1662
e: sales@simx.co.nz | www.simx.co.nz

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>