dji Osmo Action GPS Bluetooth Remote Controller User Guide

Osmo Action GPS Bluetooth Remote Controller
User Guide Osmo Action GPS
Bluetooth Remote Controller
User Guide
v1.0 2023.08

Osmo Action GPS Bluetooth Remote Controller

Disclaimer
By using this product, you signify that you have read, understand, and accept the terms and conditions of this guideline and all instructions at https://www.dji.com/osmo-action-4. EXCEPT AS EXPRESSLY PROVIDED IN AFTER- SALES SERVICE POLICIES AVAILABLE AT http://WWW.DJI.COM/SERVICE/POLICY, THE PRODUCT AND ALL MATERIALS AND CONTENT AVAILABLE THROUGH THE PRODUCT ARE PROVIDED “AS IS” AND ON “AS AVAILABLE BASIS” WITHOUT WARRANTY OR CONDITION OF ANY KIND.

Safety Guidelines

1. Put out any product fire using water, sand, a fire blanket, or a dry powder fire extinguisher.
2. The product should only be used in temperatures from -10° to 45° C (14° to 113° F).
3. DO NOT disassemble or pierce the product in any way or the battery may leak, catch fire, or explode.
4. DO NOT drop or strike the product. DO NOT place heavy objects on the product.
5. DO NOT heat the product. DO NOT put the product in a microwave oven or a pressurized container.
6. DO NOT leave the product near heat sources such as a furnace or heater. DO NOT leave the product inside of a vehicle on hot days. DO NOT store the product in environments above 45° C (113° F). The ideal storage temperature is 22° to 28° C (72° to 82°  F).
7. DO NOT store the product for an extended period after fully discharging the battery. Otherwise, the battery may over-discharge and cause irreparable damage.
8. Discharge and charge the battery completely once every three months to keep it in good working condition.

Introduction

OSMOTM
Action GPS Bluetooth Remote Controller (hereinafter referred to as “remote controller”) connects to Osmo Action 4* via Bluetooth. Users can control the camera remotely to capture footage using the remote controller. The remote controller supports single-camera and multi- camera control modes so that users can shoot with up to 16 cameras simultaneously. The built in satellite positioning modules enable users to record accurate data in motion. When used with the DJITM Mimo app, users can add a host of collected data to enrich the video, such as speed, route, direction, and elevation.
With the wrist strap, the remote controller can be installed in different places such as the handlebar of the bicycle, which can be flexibly adjusted to shoot in various sports scenes.

• Support for DJI devices will be updated continuously. Visit the corresponding DJI Osmo Action camera product page for a complete list.

Overview

1. Quick Switch Button
2. Shutter/Record Button
3. USB-C Port
4. Status LED
5. Screen
6. Link Button
7. Lanyard Hole
8. Wrist Strap Hole
9. Bluetooth RC Wrist Strap (Long)
10. Bluetooth RC Wrist Strap (Short)

Button Features

Quick Switch Button

• Press and hold: power on or off the remote controller.
• Press once: switch between shooting modes when connected to the camera.

Link Button

• Press and hold: link the remote controller and the camera.
• Press once: power on the camera when the camera is in sleep mode and connected to the remote controller. During the linking process, press once to cancel linking.

Shutter/Record Button

• Press and hold: power off the camera. When the camera is in sleep mode, press and hold to power on the camera.
• Press once: take a photo or start/stop recording. When the camera is in sleep mode, press once to start SnapShot.*

Note: both scenarios refer to situations when the remote controller is connected to the camera.

• To use the function, make sure that Wake Up Camera is enabled on the camera: swipe down from the edge of the screen and enter the control menu. Tap Settings > Bluetooth Remote Controller, and enable Wake Up Camera. This function is not available in multi-camera control mode.
  Button Combinations

  • Press and hold the shutter/record button and link button for four seconds: switch between single-camera control mode and multi-camera control mode and start linking.
  • Press and hold the quick switch button and shutter/record button for four seconds: view the firmware version of the remote controller.
  • Press and hold the quick switch button and link button for four seconds: forget the Bluetooth connection and start linking.

Screen Description

The screen displays the status of the connected camera, the battery level of the remote controller, and other information. When controlling multiple cameras, the screen displays the number of cameras connected. The display on the screen varies depending on the camera mode.

1. Verification Code: displays the verification code. When the camera is found, both the remote controller screen and the camera screen show the same verification code. Tap Accept on the camera screen.
2. GPS Signal: displays GPS signal strength. When the remote controller is searching for the GPS signal, the icon will be displayed.
3. Battery Level: displays the battery level of the remote controller.
4. Connection Status: displays the connection to the camera via Bluetooth.
5. microSD Card Information: displays either the remaining number of photos or the video duration that can be taken or recorded according to the current shooting mode. The icon is displayed only when a camera is connected.
6. Screen Information: the camera information will be synchronized when the camera is connected.

The screen will enter sleep mode if there is no operation within 3 minutes. The remote controller will power off if there is no operation after 10 minutes when there is no camera connected and the remote controller is not charging. When the screen is off, press any button to exit sleep mode and continue using the remote controller.

Operation

Installation Methods
The package includes two wrist straps of different lengths. The remote controller can be fixed to the wrist using the long wrist strap and can also be fixed to the bicycle handlebar, motorcycle handlebar, backpack strap, and other locations using the short wrist strap.
Installing the Long Wrist Strap
Fix the remote controller in a suitable position on the wrist and fasten the hook-and-loop fastener properly, as shown below.    Installing the Short Wrist Strap

1. Remove the buckle from the hole of the long wrist strap, as shown below.

2. Thread the short wrist strap through the strap slot on the back of the remote controller.
   Make sure that the side with the raised surface is facing upward.

3. Adjust the position of the remote controller on the wrist strap until one end of the strap slot reaches the raised surface. Thread the buckle through the hole on the short wrist strap.

4. Thread the strap through the buckle and fasten the hook-and-loop fastener properly.

Linking
Linking in Single-Camera Control Mode
When powered on, the remote controller automatically searches for and connects to any Osmo Action 4 cameras. Follow the prompts on the camera screen to link the devices.
Linking in Multi-Camera Control Mode
When powered on, the remote controller will be in single-camera control mode by default.
Press and hold the shutter/record and link buttons for four seconds to switch into multi-camera control mode. Then the remote controller searches for the cameras and starts the linking process. Follow the prompts on the camera screen to link the devices. When controlling multiple cameras, the screen displays the number of cameras connected.
During linking, the status LED of the remote controller will blink blue. After linking the remote controller to the camera, users can control the camera remotely to capture footage using the remote controller.

Controlling the Cameras

Single-Camera Control Mode
In single-camera control mode, press the quick switch button once to switch between shooting modes. The shooting modes that can be switched are the same as the settings in the camera. Press the shutter/record button once to take a photo or to start or stop recording.
Multi-Camera Control Mode
In multi-camera control mode, the remote controller can control each camera to use its set shooting mode to capture videos or images. Press the quick switch button to set all cameras to a unified shooting mode. Press the shutter/record button once to take a photo or start recording and press twice to stop recording. The shooting parameters will be based on the presets of each camera in this mode.

Dashboard

The built-in satellite positioning modules enable users to record fitness data accurately when shooting. When used with DJI Mimo, users can add a host of collected data to enrich the video, such as speed, route, direction, and elevation.

• Make sure to use the remote controller in an open outdoor environment to avoid signal interference and wait 1-2 minutes until the GPS signal is strong. Make sure the remote controller faces upward for the optimal GPS signal. DO NOT block the top of the remote controller with your hands or other objects.
• The remote controller does not have a GPS signal underwater. DO NOT use the remote controller underwater.

Charging the Battery
Connect the remote controller to a charger via the USB-C port. Status LED

Charging Status When Powered Off
Solid green for 6 seconds and turns off| Charging completed
Blinks green four times| Charging, 76%-100%
Blinks green three times| Charging, 51%-75%
Blinks green twice| Charging, 26%-50%
Blinks green| Charging, 0%-25%
System Status
Blinks red three times| Charging, 26%-50%
Blinks blue| Charging, 0%-25%
Operation Status
Solid green| Ready to use
Temporarily off| Take a photo
Blinks red| Recording a video

Specifications

Bluetooth
Protocol| BLE 5.0
Operating Frequency| 2.4000-2.4835 GHz
Transmitter Power (EIRP)| <10 dBm
Battery
Capacity| 270 mAh
Battery Type| Chargeable Lithium Battery
Charging Temperature| 0° to 45° C (32° to 113° F)
Operating Temperature| 10° to 45° C (14° to 113° F)

The effective remote control distance is measured in an interference-free outdoor environment without any obstacles.

CONTACT DJI SUPPORT

|
---|---
https://www.dji.com/support| http://weixin.qq.com/q/02_c1tY0_2eF410000g03s

https://www.dji.com/osmo-action-4/downloads
This content is subject to change without prior notice.
DJI and OSMO ACTION are trademarks of DJI.
Copyright © 2023 DJI OSMO All Rights Reserved

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>