iHome B15 Series Wireless Earbuds User Manual
- June 12, 2024
- iHome
Table of Contents
Model: B15 Series
Wireless Earbuds
CHARGING THE EARBUDS
CHARGE BEFORE USE
POWER ON/OFF
– Press and hold either Multi-Function Button for 5 seconds to turn the
earbuds ON/OFF.
BLUETOOTH PAIRING
– When the earbuds are ON, they will automatically enter pairing mode.
– Select ‘iHome-B15’ on your Bluetooth-enabled device to connect.
– A voice prompt will sound to indicate pairing is complete. Earbuds will
automatically
connect to your Bluetooth device whenever it is in range.
MULTI-FUNCTION BUTTON
Speakerphone
Answer/End Call| Long press MFB 2sec
Reject Call| Short press MFB twice
Voice Assistant Active
Long press MFB 3sec
LED INDICATORS
Case Charging
Charging| Solid Blue LED
Fully charged| LED OFF
Bluetooth Audio
Play/Pause| Short press MFB twice
Volume Up| Need enable the voice
assistant, use voice
command
Volume Down
Next Track
Previous Track
WARNING: Earbuds and case may present a choking hazard or cause other
injury to small children. Keep away from small children. For your safety, do
not use earbuds if they would prevent you from hearing warning sounds, such as
while riding a bike, crossing the street, etc.
Never leave a charging unit unattended. Always charge lithium devices on a
non-flammable surface – wooden tables, bedding and carpeted floors are not
recommended charging surfaces.
THIS IS NOT A TOY.
FCC ID : EMOB15A
IC : 986B-B15A
HVIN : B15a
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
-
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
-
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help. CAN ICES-3 (B) / NMB-3(B)
ISED statements
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
This device comply with ISED RF exposure requirement, users can obtain
Canadian information on RF exposure and compliance.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
ONE YEAR LIMITED WARRANTY For product support and warranty please visit:
www.ekids.com/support
Questions? Visitwww.ekids.com
©2023 SDI Technologies, Inc. All Rights Reserved.
iHome is a registered trademark of SDI Technologies Inc., used under license.