guzzanti GZ-340A Refrigerator Instruction Manual

guzzanti GZ-340A Refrigerator

PARTS AND FEATURES

1. Shelves of refrigerator chamber
2. Glass cover
3. Crisper box
4. Leveling Legs
5. Bottle Racks
6. Recessed Handle
7. Door Switch
8. Temperature Control Knob

Please read this instruction manual carefully before use and retain for future reference.

Correctly positioning

• Well Ventilating
  There is need of good ventilation around the refrigerator for easy dissipation of heat, high efficiency of refrigeration and low power consumption. For this purpose, sufficient clear space should be need around the refrigerator. Its back is at least 100mm away from the wall, its sides at least have a space of 100 mm separately and the height from over its top is not less than 200mm. A clear space should be left to open its doors to 160 °.

• Power Supply
  The refrigerator is only applied with power supply of single phase alternating current of (220-240)V~/50Hz;230V~/60Hz.If fluctuation of voltage in the district user is of so large that the voltage exceeds the above scope, for safety sake, be sure to apply a.c. automatic voltage regulator to the refrigerator. The refrigerator must employ a special power socket instead of common one with other electric appliances. Its plug must match the socket with ground wire.

• Power Line Cord
  The cord should be neither lengthened nor folded into coil during operation. Moreover, it is forbidden that cord is kept close onto the compressor at the back of the refrigerator, the surface temperature of which is quite high when operating. Touching with it would deactivate the insulation or cause leakage for electricity.

• Protection from Moisture
  Avoiding placing the refrigerator in a place where heavy moisture is present so as to minimize possibility of rusty for its metal parts. Still more, the refrigerator is forbidden to be directly sprayed by water, otherwise, poor insulation and current leakage would occur.

• Protection from Heat
  The refrigerator should be far away from any heat source or direct sunshine.

• Fixing Stable
  Floor on which refrigerator will be placed must be flat and solid. It should not be laid on any soft material such as foam plastic, etc. If the refrigerator is not on the same level, adjust the screws suitably. The refrigerator should not be placed near anything which may echo.

• Keep Away from Danger
  It is inadvisable that the refrigerator is placed near any volatilizable or combustible such as gas, petrol, alcohol, lacquer and banana oil, etc. The above-mentioned objects can not be stored in the refrigerator.

• Moving
  When fixed or moved, the refrigerator can not be set horizontally or declined to more than 45* or upside-down.

Cautions

• It must be checked that the voltage used should be the same as the rated voltage before the refrigerator is used.
• Water contained in food or getting into air inside the refrigerator by opening doors may form a layer of frost inside, It will weaken the refrigerator when the frost is thick, Defrosting on evaporator is operated manually. When the biggest thickness of the frost layer on the evaporator increase to 4mm, it must be turn off the power supply to defrost. The defrost water flow into the water collection pan through the drain port and evaporate by the heat of compressor.
• AIf the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required.
• It is dangerous to alter the specifications or attempt to modify this products in anyway.
• When you change the light bulb or when the refrigerator is not in use for long periods, disconnect it from the electricity supply.
• Wait for 5 minutes before restart the unit after the power supply blackout.

Changing the reversible door

This refrigerator has been built with the door hinges on the right. If you wish to change the opening direction, follow the instructions below:

1. Remove the upper hinge cover(6) first
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the frame. Take away the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws(8) that hold the lower hinge(2) and Make sure to Remove the lower hinge(2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the hole cover plate(7) to the right side.
7. Before placing this lower hinge(2), remove the bolt-pin (9) and reverse the direction of the lower hinge(2). Then install the lower hinge (2) onto the left side of the lower frame with two screws (8).
8. Insert the bolt-pin(9) to the lower hinge (2).
9. Set the door to its place making sure the door seat at the lower hinge(2)
10. While holding the door in the closed position secure the upper hinge (5) in the top frame of left side with two screws (1). Please remember that do not tighten the two screws(1) until the top of the door is levelled with the counter top.
11. Install the upper hinge cover(6) on the upper hinge.

Reversing the door
The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires.

Warning! When changing the side at which the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand.

• Tilt the appliance slightly towards the rear and prop it securely.
• Unscrew the door hinge screws and remove the hinge pin bracket.
• Open the door a little way and take it out downwards.
• Unscrew the upper pin and screw it into place on the opposite side.
• Fit the door into the upper pin and close it.
• Screw the hinge pin bracket securely into place on the opposite side using the screws.

Maintenance

• The refrigerator should be cleaned and maintained once a month.
• When performing maintenance, make absolutely sure that the power plug is first disconnected from the power outlet.
• Wipe the inner and outer surface of the refrigerator and its accessories with wet cloth. If they are too dirty, scrub them with neutral detergent, and then clean them with water and dry them with clean cloth. After this, a small quantify of glass wax is recommended to polish the refrigerator surface with a flannelette.
• For cleaning, don‘t use hot water, diluent, petrol, alcohol, kerosene, washing powder, cleanser, aikailinous detergent, acid, Chemical cloth, etc. So as not to damage the lacquer coat and plastics.
• It is forbidden than the refrigerator is directly sprayed with water. Otherwise, it would cause rusty or weaken the insulation.
• Be careful to upkeep the sealing rubber bars of the doors. They should always be cleaned.
• If the plastic parts in refrigerator remain contaminated for a long time by oil (animal or vegetable), they will be easy aged and possibly cracked. The drain pan gets dirty very easily if it is not cleaned regularly, bad odours will be produced, get into the habit of cleaning this pan regularly.

Troubleshooting

1. When the refrigerator does not work

   • Check if there is a power failure.
   • Check if the power plug is plugged into the power outlet.
   • Check that the fuse has not blown.

2. When the refrigerator is cooling excessively

   • The temperature control dial may be set too high.
   • If you place foodstuffs containing a lot of moisture directly under the cool air outlets, they will freeze easily. This does not indicate a malfunction.

3. When the refrigerator is not cooling sufficiently

   • The food may be packed too tightly together which will block the flow of cool air.
   • You may have put something hot or a lot of foodstuffs into the refrigerator.
   • The door may not have been closed properly.
   • The door gaskets may be damaged.
   • The refrigerator may not be ventilated.
   • There may be insufficient clearance between the refrigerator and the surfaces
   • Immediately both sides and above.
   • The temperature control dial may not be set properly.

4. When the defrosting water overflows inside the refrigerator and onto the floor.

   • Check that the drain pipe and the drain hose are not clogged.
     Check that the drain pan is housed properly.
     Whether the thickness of the frost layer was thicker than 4mm when you make the refrigerator defrost.

5. When condensation form on the outside of the refrigerator.
   Condensation may form on the outside when the humidity is high such as during a wet season. This is the same result as the condensation formed when chilled water is poured into a glass. It does not, therefore, indicate a failure, wipe dry with a dry cloth.

6. When you hear a sound like water flowing .
   A sound like water flowing is the refrigerant flowing. It does not Indicate a malfunction.

7. When the cabinet‘s side panel heats up
   The side panel of the cabinet will heat up when the door is opened or closed frequently, when starting the unit and when the unit operates in summer with high ambient outside temperature, In such case, do not touch the panel, it results from the dissipation of the heat from inside the cabinet, and it does not mean that something is wrong with the refrigerator.

Technical specifications

• For the detailed technical specifications, please refer to the nameplate at the back of the refrigerator.
• Specifications are subject to change without prior notice.

DISPOSAL

DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
This symbol on products or original documents means that used electric or electronic products must not be added to ordinary municipal waste. For proper disposal, renewal and recycling hand over these appliances to determined collection points. Alternatively, in some European Union states or other European countries you may return your appliances to the local retailer when buying an equivalent new appliance. Correct disposal of this product helps save valuable natural resources and prevents potential negative effects on the environment and human health, which could result from improper waste disposal. Ask your local authorities or collection facility for more details. In accordance with national regulations penalties may be imposed for the incorrect disposal of this type of waste.

For business entities in European Union states
If you want to dispose of electric or electronic appliances, ask your retailer or supplier for the necessary information.

Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of this product, request the necessary information about the correct disposal method from the local council or from your retailer.

Product Information Sheet

Product Information Sheet

COMMISSION DELEGATED REGULATION (EU) 2019/2016

Supplier’s name or trademark: Guzzanti
Supplier’s address: Na Zlatnici 301/2, 14700 Praha 4, CZ
Model identifier: GZ-340A
Type of refrigerating appliance:
Low-noise appliance:| No| Design type:| –
Wine storage appliance:| No| Other refrigerating appliance:| Yes
General product parameters:
Parameter| Value| Parameter| Value
Overal dimensions (millimetre)| Height| 1700| Total volume (dm³ or l)| 331
Width| 600
Depth| 600
EEI| 124| Energy efficiency class| E
Airborne acoustical noise emissions (dB(A) re 1 pW)| 40| Airborne acoustical noise emission class| C
Annual energy consumption (kWh/a)| 114| Climate class:| subtropical, tropical
Minimum ambient temperature (ºC), for which the refrigerating appliance is suitable| 16| Maximum ambient temperature (ºC), for which the refrigerating appliance is suitable| 38
Winter setting| No|
Compartment Parameters:
Compartment type| Compartment parameters and values
Compartment volume (dm³ or l)| Recommended temperature setting for optimised food storage (ºC) These settings shall not contradict the storage conditions set out in Annex IV, Table 3| Freezing capacity (kg/24h)| Defrosting type (auto-defrost=A, manual defrost=M)
Pantry| No| –| –| –| –
Wine storage| No| –| –| –| –
Cellar| No| –| –| –| –
Fresh food| No| –| –| –| –
Chill| No| –| –| –| –
0-star or ice-making| No| –| –| –| –
1-star| No| –| –| –| –
---|---|---|---|---|---
2-star| No| –| –| –| –
3-star| No| –| –| –| –
4-star| No| –| –| –| –
2-star section| No| –| –| –| –
Variable temperature compartment| –| –| –| –| –
Light source parameters:
Type of light source| –
Energy efficiency class| –
Minimum duration of the guarantee offered by the manufacturer: –
Additional information:
Weblink to the manufacturer’s website, where the information in point4(a) Annex of Commission Regulation (EU) 2019/2019 is found: –

References

• ČERTES - Prodej a servis elektroniky
• Privest s.r.o.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>