Knightsbridge TORODO LED Downward Coach Lantern Instruction Manual

: June 12, 2024
: Knightsbridge

Table of Contents

GENERAL INSTRUCTIONS
SAFETY
INSTALLATION
GENERAL
WARRANTY
SUPPLIED BY:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Knightsbridge TORODO LED Downward Coach Lantern

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for future reference and maintenance.
These instructions should be used to aid installation of the following products: TOROUP /TOR ODO

SAFETY

This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (B57671) and current Building Regulations. If in any doubt. consult a qualified electrician
Please isolate mains prior to installation or maintenance
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the circuit cable. fuse. or circuit breaker
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
This product is Class II double insulated
This product is IP44 rated

INSTALLATION

Note – If this luminaire is being used in conjunction with an external PIR or sensor. please confirm with the manufacturer of the sensors that they are compatible with LED lamps.

Provide power to the required point of installation (refer to 8S7671 for correct cabling methods). Sui~able IP rated junction boxes should be used where required
Remove the baseplate from the luminaire body by loosening the screws on either side of the base (see Fig. 1)
Round cable should be used for the mains supply. The use of flat cable will cause water ingress to the fitting
Using the baseplate as a template. mark the location for. and drill the fixing holes ensuring not to infringe with any gas/water pipes or electrical cables (see Fig. 1)
Feed the mains cable through the rubber grommet to retain IP rating. and secure the baseplate to the surface using the screws and wall plugs provided
Connect the luminaire to the mains supply ensuring the correct polarity is observed: L – Live (brown) and N – Neutral (blue)
The colour temperature can be selected by the 2-position switch inside the luminaire body
Align the luminaire body with the baseplate and refasten the screws
Switch on and check for correct operation

GENERAL

This product contains a light source of energy efficiency class F to Regulation (EU) No.
2019/2015 and (UK) 2021 No. 1095.
This product contains a non-replaceable LED light source and a non-replaceable control gear.

Clean the external surfaces with a damp doth using a mild solution of detergent and warm water only. do not use aggressive cleaning products or solvents which may damage the product.
This product should be dismantled for disposal when it reaches the end of its life. Please see website for d is mantling instructions.
This product should be recycled in the connect manner when it reaches the end of its life.
Check local authorities for where facilities exist.

WARRANTY

This product has a warranty of 3 years from date of purchase. Failure to install this product in accordance with the current edition of the IEE Wiring Regulations (B57671). improper use. or removal of the batch code will invalidate the warranty. If this product should fail within its warranty period. it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve the right to alter product specification without prior notice .