LUXLOGIC CCTS Rome Track Light Installation Guide
- June 12, 2024
- LuxLogic
Table of Contents
LED TRACK LIGHT
INSTRUCTION
CCTS Rome Track Light
READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS BEFORE INSTALLING OR MAINTAINING
THIS PRODUCT.
DO NOT INSTALL DAMAGED PRODUCT.
This fixture must be installed according to the National Electric Code and
local building codeds.
Do not install in damp or wet locations.
Do not install luminaire assembly closer than six (6) inches from any curtain
or similar combustible material.
Do not use this track with a power supply cord or convenience receptacle
adapter.
Do not attempt to energize anything other than the lighting track luminaires
on the track.
There are no user servicable parts inside. Opening unit will void warranty.
Contact point of purchase for service.
Installation Instruction
To install the fixture to the track:
Step 1. Pull back the adapter latch
Step 2. Insert the contact assembly into the track.
Step 3. Rotate the fixture neck 90° so the contacts on the fixture align with
the contacts on the track
Step 4. Release the adapter latch allowing the fixture to lock into position
(Fig. 1)
Step 5. Turn the track head connector to ‘ON’ (Fig. 4)
To remove the fixture:
Step 1. Turn the track head connector to ‘OFF’ (Fig. 4)
Step 2. Slide the adapter latch down until latch is clear of the track channel
opening.
Step 3. Twist the fixture neck and turn (90°) until the contact assembly is
free.
Step 4. Remove fixture from track.