Fisher and Paykel DD60DCHX9 Dishdrawer Dishwasher User Guide

June 10, 2024
FISHER and PAYKEL

Fisher-and-Paykel-logo

Fisher and Paykel DD60DCHX9 Dishdrawer Dishwasher

Fisher-and-Paykel-DD60DCHX9-Dishdrawer-Dishwasher-
product

Product Information

The DishDrawer™ Dishwasher is a high-performance dishwasher that uses rotating spray arms to clean dishes. The dishwasher is available in both single and double models, with the double model allowing each drawer to run independently of the other. The dishwasher has a maximum plate height of 280mm for standard tubs or 310mm for tall tubs. It features a detergent dispenser, rinse aid dispenser, wash selector, wash modifiers selector, start/delay start button and drawer selector (double models only). The dishwasher is easy to use and maintain, ensuring that your dishes are always clean and ready to use.

Product Usage Instructions

  1. Discard scraps and remove any foreign objects from dishes before loading them into the dishwasher.
  2. Load dishes carefully, ensuring that they are evenly spaced and not nesting.
  3. Check that the spray arms are mounted correctly and can rotate fully around. Before starting a wash, ensure that there are no items blocking the spray arms from rotating.
  4. Fill the detergent dispenser with powdered detergent and close the dispenser door. Do not place liquid detergent or tablets in the detergent dispenser. If using a tablet or gel pouch, place it in the cutlery basket or at the edge of the base rack.
  5. Check the rinse aid dispenser and refill it with liquid rinse aid if necessary. Make sure to refit the rinse aid plug back into its original position by rotating the plug back into an upright position.
  6. Power on the dishwasher and select the wash program using the wash selector button. Use the wash modifiers selector to select additional wash options if desired.
  7. To start a wash, close the drawer(s) and press the start button. To set a delay start, press and hold the delay start button and then press and hold again to increase the delay start time.
  8. If you need assistance or replacement parts, refer to the contact information provided in the user guide or service & warranty booklet.

Keep this document handy for easy reference.

  • For detailed information on the features of your dishwasher, see your ‘User guide’.
  • Before using your dishwasher, make sure you read the full ‘User guide’, with special attention to the ‘Safety and warnings’ section.
  • For contact information or if you require service, assistance or replacement parts, see the end of this document or your ‘Service & warranty’ booklet.

YOUR MODEL

Double model

  • DD60DCHX9

Single model

  • DD60SCHX9

Note:
Each drawer can run independently of the other drawer.

OPERATING INSTRUCTIONS STARTING A WASH

  1. Discard scraps
    Scrape large food particles off (e.g. bones, fruit stones) and remove any foreign objects (e.g. toothpicks, strings, paper).

  2. Load dishes carefully
    To help with wash performance, arrange dishes so they are evenly spaced and not nesting.
    IMPORTANT!
    Accommodates plates up to a max height of 280mm (11”) for standard tubs or 310mm (12 1/4”) for tall tubs.

  3. Check spray arm(s) are mounted correctly and can rotate fully around
    Check the spray arm is mounted correctly by physically rotating it around with your hand. Before a wash, ensure there are no items blocking the spray arm(s) from rotating.

  4. Add detergent
    Fill the detergent dispenser (A) with powdered detergent and close the dispenser door.
    IMPORTANT!
    Do not place liquid detergent or tablets in the detergent dispenser.

  5. If using a tablet or gel pouch, place it in the cutlery basket (B) or at the edge of the base rack (see user guide for details)

  6. Check rinse aid
    If the indicator on its plug (C) glows bright red, refill the rinse aid dispenser (D) with liquid rinse aid. Make sure you then refit the rinse aid plug back into its original position, by rotating the plug back into an upright position.

  7. Select wash
    Power the dishwasher on then select the wash program .

  8. Start wash or set Delay start
    To start wash:
    Close the drawer and press .
    To set delay start:
    Press and hold to enter delay start, then press and hold again to increase the delay start time.

CONTROLS AND DISPLAY

Single models

Double models

Controls Description

A-Off/On
Opening the drawer will automatically turn the dishwasher on.

Single models:
Press to turn the dish drawer on or off.

Double models:

  • Press to turn the dish drawer on.
  • Press and hold to turn the dish drawer off.

Drawer selector (Double models only)
Press to scroll between drawers.

B-Wash selector
Press to scroll through wash program options.

C-Wash modifiers selector
Press to scroll through the wash modifier options.
Note: Not all modifiers are available for all wash programs.

D Start / Delay Start
Press to start the wash.

To pause:
Press again. The wash stage indicator wash and (Double models) will flash.

  • Wait for the 3 short and one long tones before opening the drawer. Forcing it open mid-cycle may cause damage or injury.
  • If the drawer is not restarted within 7 minutes it will tone intermittently until it is restarted.

To Delay start

  1. Press and hold until 1h appears on the display, then release. You are now in Delay start mode.
  2. Press until the display shows the number of hours you want to delay the start of a wash by (1 to 12 hours).
    • Note: If you scroll past 12 hours the dishwasher will exit Delay start mode. To re-enter delay start follow step 1 above.
    • The wash will start once the delay time is over, provided the drawer is closed.

DD24 models only
If the drawer is opened after delay start has been set (for example if you need to load more dishes), delay start will be paused after the drawer is closed.

To restart delay start:
Close the drawer.

  • Single models: ****will flash.
  • Double models: and ****will flash.
  • Press to resume.

Cancel wash / Cancel Delay start

Single models:
Press to cancel a wash that has already started or to cancel the Delay start setting.

Double models:
Press and hold to cancel a wash that has already started or to cancel the delay start setting.

  • If there is any water in the drawer, it will automatically drain before the dishwasher turns off.

E Keylock
Keylock disables all the buttons – helpful when cleaning the dishwasher.

To activate:
Press and hold together until you hear one tone. The keylock indicator will come on.

To cancel:
Press and hold and together until you hear another tone and the keylock indicator stops flashing and goes out

Child lock
Childlock disables all the buttons and locks the drawer closed, preventing unauthorized use by children.

To activate:
press and hold and together until you hear a second tone. The keylock indicator will come on.

To cancel:
Press and hold and together until you hear another tone and the keylock indicator stops flashing and goes out.

F Wash program indicators
These show which program is selected.

G Drawer indicator (Double models only)

  • White: drawer is running and selected.
  • Dim: drawer is running but not selected.
  • Flashing: drawer is paused

H Display

  • Time remaining (minutes)
  • Fault code numbers (see ‘If there is a fault’ in User guide).

J Keylock/Child lock indicator
If lit: the keylock or child lock is activated.

K Delayed start indicator
If lit: a delayed start is set.

L Salt indicator
(Water softener models only)
If lit: salt reservoir is empty.

M Wash modifiers indicators
If lit: the wash modifier is selected.

WASH PROGRAMS

Double models interface shownFisher-and-Paykel-DD60DCHX9-Dishdrawer-
Dishwasher-fig- \(32\)

DURING AND AFTER THE WASH

As the wash progresses, the display will count down the minutes remaining and show what stage the program is at. When the program has finished, the display will show 0 and the dishwasher will sound a tone. After 30 seconds the display will go out.

You may notice the following noises at the end of the wash. These are all part of normal operation:

  • Both drawers may be draining simultaneously.
  • The drying fan may continue to run after a wash program has finished for a set time or until the drawer is opened. The fan assists with drying and uses negligible amounts of energy.

For best drying results, we recommend unloading the dishes once they have cooled.

DOS AND DON’TS OF LOADING

  • Sharp or pointed items must be placed horizontally or with sharp edges/points facing down to avoid risk of injury.
  • A neatly arranged load with evenly spaced dishes helps wash performance.
  • Ensure there is enough space between plates. Mix spoons, knives and forks within the cutlery basket to prevent them from nesting.
  • Ensure that water reaches all items on the racks.
  • Protruding items will stop the internal lid of the dishwasher from sealing properly, which could result in a service call.
  • Overcrowding reduces wash performance.
  • If plates and cutlery are nesting, they are less likely to be cleaned well.
  • Dishware is blocking water from reaching items on the racks.

PREFERENCE OPTIONS

You can change the setting of these options to suit your preferences or circumstances. We recommend selecting the most suitable settings before you start using your dishwasher.Fisher-and-Paykel-DD60DCHX9-Dishdrawer-
Dishwasher-fig- \(33\)

How to change the setting of an option

  1. CHECK
    Check that there is no wash underway, press

  2. ENTER MENU & SCROLL TO OPTION
    To enter the menu: Press and hold the and together for four seconds.

    • You are now in the Rinse aid option of the preference options menu.
    • If you want to change the Rinse aid setting, go to step 3 now.
    • If you want to change the setting of another option, you will need to scroll to that option first.
      To scroll to the next option: press . To know which option you’re in, watch the letters in the display (see table below). When you have scrolled to the end of the sequence, the menu will start again with Rinse aid.Fisher-and-
Paykel-DD60DCHX9-Dishdrawer-Dishwasher-fig- \(31\)
  3. CHANGE SETTING
    Press to change the setting within an option. For example, to change the Rinse aid setting from 4 (factory default) to 2, you need to press 3 times.

  4. SAVE SETTING & QUIT MENU
    Press . This will save the new setting and quit the preference options menu.

FOR MORE INFORMATION

  • For detailed information on the features of your dishwasher see your ‘User Guide’

  • For warranty information see your ‘Service and warranty booklet
    If you

    • have any questions or comments
    • need a Fisher & Paykel authorized technician to service your product
    • need replacement parts or accessories
    • want to register your product at www.fisherpaykel.com.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

FISHER and PAYKEL User Manuals

Related Manuals