OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware Instruction Manual

June 12, 2024
OUTWATER

THE TOWNHOUSE
Hardware kit for sliding single wood door.
304 Grade Stainless Steel

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware

MODEL No.
SDH-SW03-SS-8-NR
INSTALLATION MANUAL

TOOLS REQUIRED

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 1

  • Plumb Line
  • Pencil
  • Phillips Head Screwdriver
  • 10mm Drill Bit
  • 5.5mm Drill Bit
  • Level
  • Tape Measure
  • Power Drill

INCLUDED IN KIT

A 96″ Rail x1
B Door Roller Hardware x2
C End Bracket x2
D Center Bracket x3
E ST4.8×50 Bolt x5
F ST5.5×32 Screw x4
G Floor Anchor x4
H Non-Routed Floor Guide x2
I Door Stops x2
J 4mm/6mm Allen Keys x1

Architectural Products by Out water assumes no liability for improper installation.

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 2

NOTES

  1. To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board.
  2. Adjustable mounting brackets allow for standard 16″ U.S. stud spacing, or any variation.

Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking.
Attach the wall portion of the brackets as shown.
Consult a structural engineer if you have questions about what type of wall blocking is required.

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 3

Suggested wall bracket spacing.
Brackets must be secured into wall blocking.

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 4

Attach rail to wall as shown.

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 5

Remove the anti-rise pin using the provide Allen key.
Drill holes in the top of the door from the edge as pictured to accommodate the door rollers.

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 6

Position the doors on the rail.

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 7

Plumb the door and fastem the metal floor guides to the floor using the screws and anchors provided. The opening will depend on the thickness of your door. The guides are adjustable and will accept any thickness.

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 8

Adjust the door stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment.

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 9

Reattach the anti-rise pin to the door rollers

OUTWATER SDH-SW03-SS-8-NR Barn Door Hardware - Fig 10

Architectural Products by Out water assumes no liability for improper installation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

OUTWATER User Manuals

Related Manuals