OUTWATER SDH-SW12-SS Barn Door Hardware Instruction Manual

OUTWATER SDH-SW12-SS Barn Door Hardware Instruction Manual

Package Content

TOOLS REQUIRED

• Plumb Line
• Pencil
• Phillips Head Screwdriver
• 10mm Drill Bit
• 5.5mm Drill Bit
• Level
• Tape Measure
• Power Drill

INCLUDED IN KIT

Dimension

1. To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board.
2. Adjustable mounting brackets allow for standard 16″ U.S. stud spacing, or any variation.

Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking.

Attach the wall portion of the brackets as shown.
Consult a structural engineer if you have questions about what type of wall blocking is required.

Architectural Products by Outwater assumes no liability for improper installation.

Assembly Instructions

1. Suggested wall bracket spacing.
   Brackets must be secured into wall blocking.

2. Attach rail to wall as shown.

3. Remove the anti-rise pin and drill holes centered in door thickness. The door should be routed at this time.
   Mount the rolling straps to the door and position the door on the rail.

4. Adjust the stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment.

5. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor.

6. Adjust the door stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment.

7. Reattach the anti-rise pin to the door rollers

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>