FSDH-TOPKT Furniture Sliding Door Hardware Kit Instruction Manual
- June 12, 2024
- FURNITURE
Table of Contents
MODEL No.
*FSDH-TOPKT--10-DD
INSTALLATION MANUAL**
TOOLS REQUIRED
- Plumb Line
- Pencil
- Phillips Head Screwdriver
- 4mm Drill Bit
- Wrench
- Level
- Power Drill
- Tape Measure
INCLUDED IN KIT
| A | Door Roller Hardware | x4 |
|---|---|---|
| B | Anti-Jump Disk | x4 |
| C | Adjustable Door Stop | x2 |
| D | End Cap | x2 |
| E | Mounting Bracket for ” and 1″ Doors | x8 ea. |
| F | M6x60 Bolt + Washer | x16 |
| G | Routed Door Guide | x2 |
| H | ST4.2×35 Screw | x4 |
| I | Anchor | x4 |
| J | 1.5mm Allen Key | x2 |
| K | Hole Cover | x4 |
| L | Splicer + Screws | x1 |
| M | 60″ Rail | x2 |
PLEASE NOTE: The installation manual is a suggested guideline.
Adjustments may need to be made based on your specific application.
Architectural Products by Cutwater assumes no liability for improper
installation.
UNDERSTANDING YOUR RAILS
LEFT RAIL
RIGHT RAIL
LEFT AND RIGHT RAILS JOINED BY SPLICER
INSTALLATION
Using a pencil, mark the locations where you will drill holes as indicated.
Before beginning installation, attach the door stops [C] to both rails [M].
Architectural Products by Outwater assumes no liability for improper
installation.
Using a power drill with a 4mm drill bit, drill holes as indicated.
- Install the first rail, and mounting brackets [E].
- Line up the second rail against the first and install with mounting brackets. Secure the two rails with the splicer [L].
NOTE: If mounting to a wall, fasteners must be mounted into solid wood studs, wall blocking or, a wood header board when additional projection is needed. (Example: When using as TV shutters)
Drill holes into the doors as indicated. Attach the door rollers [A].
It is suggested that the door rollers [A] be mounted 5″ from the edge of the
doors to the neck of the rollers.
NOTE: Trimming the rail will alter the position of the roller hardware. Adjust
accordingly.
FOR ¾” DOORS
FOR 1″ DOORS
Allow a minimum 3-1/8″ clearance above the doors.
Architectural Products by Outwater assumes no liability for improper
installation.
Attach the doors to the rail [L] and lock the anti-jump disks [B] into
position. Doors should be routed beforehand if using the routed door guides [G
].
If using the routed door guides [G], install them at this time.
Repeat steps 4-7 for additional door.
Use the hole covers [K] to give the rail a finished look.
Once cut, add the end caps [D] to the ends of the rail and secure with a set
screw.
The rail can be trimmed if necessary using a band saw or hacksaw. Use blades
suitable for iron or stainless steel depending on your rail.
NOTE: If you are trimming the rail, do so equally. Each rail can be
trimmed equally up to 2½” from one (1) side of each length of rail. Holes for
splicer must remain intact on one side of the rail. However; trimming will
alter the position of the roller hardware. Adjust accordingly.
Maximum T.V. size of 60″ with a width of 56″
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>