SCANGRIP 03.5132 Flash Boost 300 Instruction Manual
- June 12, 2024
- SCANGRIP
Table of Contents
FLASH 300
03.5132
// Remove inside battery protection before use
Push the switch for 2 sec to activate boost mode. Normal mode after 60 sec.
3 x AAA
*3 years warranty
* go to scangrip.com to register
SCANGRIP flashlights are tested according to the ANSI/NEMA FL1 standard
CREE 165 lm/W 150 lumen/ 300 lumen boost
600-10000 lux@0.5m 10°- 60° 3xAAA/1.5V Alkaline
3h -10° to +40° C 1m
IK07 IP54 ø32X133 mm
122g
BATTERY TIPS
- Never attempt to recharge the batteries or mix new and used batteries. Always use matching high-quality batteries of the same type. Use of alkaline batteries is recommended. To prevent leakage from the batteries, remove them from the lamp if it is not to be used for an extended period. Spent batteries should be removed and disposed of as hazardous waste in accordance with national legislation. To maintain the battery capacity the lamp should be stored at room. temperature.
Consumers are legally obligated to hand batteries in at an environmental station or recycling facility, or to return them to the retailer. The WEEE symbol means batteries must not be disposed of together with household waste
MANUFACTURER’S WARRANTY - Information for customers in Australia and New Zealand only
This SCANGRIP product is guaranteed for a period of 2 (two) years from date of
purchase. This guarantee shall become invalid if the product has been misused,
tampered with or accidentally damaged.
If the product is defective, we undertake to repair or replace the product or
any part of it that is defective; or wholly or partly recompense you if they
are defective.
This guarantee is in addition to other rights and remedies available to consumers, all of which are given by us to you if you are a consumer. Our goods come with guarantees that cannot be excluded under the Australian or New Zealand Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
If you wish to make claim, please return this product to the original place of purchase together with your purchase receipt or go to our website www.scangrip.com and fill out the claim form.
DESIGNED BY
SCANGRIP
IN DENMARK
EU DESIGN PATENT 7180187
V4/16.11.2021/MS
// SCANGRIP A/S Rytterhaven 9 DK-5700 DENMARK
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>