MateStar Mat-240BK Quartz Heater Instruction Manual

: June 12, 2024
: MateStar

Table of Contents

DESCRIPTION
ASSEMBLY
OPERATION
CLEANING
STORAGE
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

QUARTZ HEATER MateStar Mat-240BK Quartz Heater For out door use
INSTRUCTION MANUAL
WWW.MATESTAR.EU

INSTRUCTION MANUAL FOR QUARTZ HEATER MOD. MAT-240BK /MAT-240R

DESCRIPTION

MateStar Mat-240BK Quartz Heater - Handie

Voltage: 220-24W
Frequency:50-60Hz
Two heating power: 1100W/2200W,IFX4
Quart heating element
With thermostat protection
Tip-over switrh protection

ASSEMBLY

Carefully turn the appliance upside down to fit the castors.
Slide the wheel plate at the right position.
Secure the wheel plate by lightening the butterfly nut.
Put the appliance In the upright position.
Take out the cable from the cable bracket backside.

OPERATION

Switch the heater to one of the following power settings:
• I — low heating power;
• II — high heating power;
NOTE! This device will cool slowly after the power is Shut off. Allow the heater to cool prior to any movement. The built-In carry handle should be used for easy movement When this device is overheated it Is automatically turned off by a special security system. Unplug the device and let It cool down before activating it again.
Once you finished using the heater, turn the power switches to the “OFF” position, then unplug the main power supply.

CLEANING

If not used for a long time, dean the heater’s surface and keep it in the original packing. Keep the heater in airy place and pay attention to avoid dampness.
Use a damp cloth to dean the surface of appliance, avoid water going inside the appliance, and thy the appliance before use or store.

STORAGE

Save the original packing for the off-season storage.
Clean the heater according to the cleaning Instructions above.
Remove the wheel base assemblies.
Place the heater and the wheel assemblies in the original packing and store in dry place.

SAFETY REGULATIONS

The heaterrkshould be put and used in the suitable place, forbid putting the heater under the power
In the range that can be radiated around the heater, forbid putting flammable, in accordance with explosion articles. The occasion that can’t be used which is full of flammable gas and dust either.
The heater should be more than 1 meter away from the flammable material, and avoid the fixed irradiation for a long tine.
The heater should be put on a smooth solid tabletop or ground to work.
The cable should be put well, and avoid tripping over the heater while walking, the cable must keep away the top part of the heater, forbid the cable touch the radiation cover and the net cover, forbid being heated by the Infrared closely.
Can’t hang the clothes dripping or drench with rain above the heater, avoid entering water and leaking electricity dangerously, avoid covering flammable things on the radiation cover and the net cover, avoid taking place the fire and get an electric shock dangerously.
The socket cable should keep in touch the ground well, should select the qualified socket.
The he voltage of the power, frequency should accord with the technical parameter request of the heater.
Ammeter and cable connecting up Inside must load the power of heater, also should consider of loading other electric appliances at the same time.
Forbid touching the radiation cover when it is working, in order to prevent the high temperature from scalding the skin.
Forbid working when pull down the net cover.
When stop using, should pull out the plug carefully, and turn off the heater before purling out, don’t draw cable with hand.
Should pack the machine well when won’t use it for a long time, prevent the dust, deposit to a dry and ventilate place.
When only child, animal, people lack for self-control or difficulty moving themselves In the room, and nobody nurse them, should avoid using it.
This heater is not equiped with device to control the room temperature, don’t use this heater in small room where they are occupied by person not capable of leaving the room on their own unless consistent supervision is provided.
If the machine couldn’t work normally, please contact the after-sale service for repair, avoid breaking it down and change the fittings without permission.
When It is covered or furnished in a incorrect position, It may catch fire, so please don’t set the heater as starting automatically; It must be turned off when the electrical power is cut, avoid working automatically when the incoming electricity and nobody In the room..
When the heater which deposit In -20t severe cold place, must intensify it above -20r before using it, prevent material from changing the characteristic in the low temperature.
Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned Incorrectly.
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
WARNING: In order to avoid overheating, do not cover the heater.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
The appliance is not intended for use by persons (Including children) with reduced physical, sensory or mental capabikties, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should he supervised to ensure that they do not play with the appliance.

SAFEGUARD AND MAINTAIN

Please pull out the plug and cool it to the normal temperature before safeguarding and maintaining.
It’s easy to accumulate of dust on the appearance, should dean It frequently with soft cloth. Must pull down the screws and nut, take off the net cover before cleaning the inner surface of the radiation cover. Avoid using a wet or flammable soft cloth to clean the heat device, also avoid hanging soft cloth or other flammable things on it It must set up the net cover and fix the screws after cleaning.
When the surface Is too dirty, could be polished with water lower than 50C and mixed with neutral detergent, then dry it.
When do cleaning, avoid using the petrol, diluent, sour things or any other chemical things and the materials which may damage the heaters’ surface easily.
Should cool it to the normal temperature, dry it, and pack it carefully, then deposit to a dry and ventilative place.

OBSTACLE ELIMINATE

If the heater don’t heat up after starting the machine, please check whether the power is normal, whether the socket is good, retry it after checking carefully.
Please send it to the service department for other obstacles.
There is safety switch at the bottom of the heater, and when it fall down, the switch would cut off the electricity automatically, and it stop working, make it perpendicularity and turn on the machine, it would be working normally.

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health, deriving form inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product Is marked with a crossed-out wheeled dustbin.
PLEASE FILL YOUR DETAILS FOR FUTURE USE