MateStar MAT-12HB Quartz Heater Instruction Manual

MAT-12HB Quartz Heater
Instruction Manual

MAT-12HB Quartz Heater

INSTRUCTION MANUAL
Quartz Heater
Model: MAT-12HB
Made in PRC
Imported by
ROMICO J.T. TRADERS LTD
11 DIOS STR., 1056 NICOSIA- CYPRUS
Tel. 22430310
WWW.MateStar.EU

DESCRIPTION OF THE SYMBOLS

Before any use, refer to the corresponding section in this user
** In accordance with European directives applicable to this product.
Warning: In order to avoid overheating, do not cover the heater.
Caution, hot surface.**
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment.

GENERAL SAFETY INFORMATION

1. Read all instructions carefully before using the appliance.

2. Make sure the voltage is the same as that indicated on the rating plate of the appliance.

3. Do not operate this appliance if the cable or plug becomes damaged.

4. Keep the appliance and cable away from sources of heat, sharp objects or anything that may cause damage.

5. If the cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

6. Ensure the appliance is switched off before connecting to the mains power supply.

7. Switch off the power supply and disconnect from mains supply when not in use, before cleaning or other maintenance.

8. To disconnect the appliance, switch it “0”, and then remove the plug from outlet. Do not pull the cord to disconnect the plug.

9. The heater must not be located immediately below a socket-outlet.

10. Do not operate in areas where gasoline, paint or other flammable liquids are used or stored.

11. Indoor use only.

12. In order to avoid overheating, do not cover the heater.

13. To prevent a possible fire, do not block air intakes or exhaust in any manner.

14. Don’t touch the hot surfaces.

15. Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock, fire or damage to the appliance.

16. Always ensure that hands are dry before operating or adjusting any switch on the product or touching the plug and socket-outlet.

17. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and  knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shail not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

18. Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shall onlyswitch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
    Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
    CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

19. Do not leave this appliance unattended when it’s in use.

20. The most common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are removed regularly by disconnect the appliance and vacuum cleaning air vents and grilles.

21. Do not place the heater on carpet, don’t place the cable under carpets. Arrange cord away from traffic areas so that it will not be tripped over.

22. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.

23. Do not store away until the heater cools down, store the heater in cool dry location when not in use.

TECHNICAL SPECIFICATIONS

PRODUCT DESCRIPTION

1. Aluminium housing
2. Heating tubes
3. Pull cord switch

ASSEMBLY

WARNING!
Ensure a sufficient distance from the wall (min. 20 cm at the sides), ceiling (min. 35 cm), floor (min. 1.8 m), fixtures (min. 1 m) or other appliances (min. 1 m), to prevent damage or the risk of fire.

Only use the fastening bracket provided for fixing the appliance to the wall, to ensure the necessary distance from the rear wall.
Drill 3 holes with diameter 6 mm in the wall, to match the holes in the fastenin bracket.
Clean the drill hole from the drilling dust because the wall plugs could otherwise jam, insert the wall plugs into the holes. Firml screw in the fastenin bracket.
Note: We recommend fastening the fastening bracket to a solid wall-of masonry or concrete.
Align the back card slot with the fastening bracket, and fix the product along the direction of the arrow.
Hang the device on the wall and tighten the screw with the fastening bracket.

OPERATION

1. Always close or cover your eyes when radiating the face.
2. Switch the appliance on by inserting the plug into a mains socket that conforms to the technical data.
3. Switch the appliance off by removing the plug from the mains socket.

Operating switch
Pull the drawing switch, the operating switch has 2 positions and the heating levels on and off.

MAINTENANCE

1. Always disconnect the appliance and let it completely cool before any maintenance.
2. Use a vacuum cleaner to remove dust on grilles.
3. Clean the outside of the unit with a damp cloth and then dry it with a dry cloth. Never immerse the unit in water, nor let water drip into the unit.

STORING

1. Always disconnect the appliance, let it completely cool and clean it before storing.
2. If you do not use the device for a long period, put back the unit and the instruction manual to the original carton and store in a dry and ventilated place.
3. Do not place any heavy items on top of carton during storing as this may damage the appliance.
4.   IMPORTANT: Please always put away the unit upright horizontally. Or it will affect the heating performance greatly during operation.

Information requirements for electric local space heaters

Maximu m
continu ous
heat output| P max.c| 1.| KW| Electronic heater charge control with room and/or outdoor temperature feedback| [no]
Auxiliary electricity consumption| Fan assisted heat output| [no]
At nominal heat output| elmax| 0 kW| Type of heat output / room temperature control (select one)
At minimum heat output| el min| 0 kW| single stage heat output and no room temperature control| [no]
In standby mode| el SB| 0 kW| Two or more manual stages, no room temperature control| [yes]
| | | with mechanic thermostat room temperature control| [no]
| | | with electronic room temperature control| [no]
| | | electronic room temperature control plus day timer| [no]
| | | electronic room temperature control plus week timer| [no]
| | | Other control options (multiple selections possible)
| :| | | room temperature control, with
presence detection| [no]
---|---|---|---|---|---
| | | | room temperature control,
with open window detection  with distance control option| [no] [no]
|
| | | | with adaptive start control| [no]
| | | | with working time limitation| [no]
| | | | with black bulb sensor| [no]
Contact details|

PLEASE FILL YOUR DETAILS FOR FUTURE USE
GUARANTEE CARD
CUSTOMER’S DETAILS…………………..
NAME OF BUYER…………………………..
ADDRESS TELEPHONE………………….
DETAILS OF SHOP……………………..
NAME OF SHOP…………………………..
RECEIPT VOUCHER NO…………………
DATE OF PURCHASE……………………..
APPLIANCE DETAILS………………….
TYPE OF APPLIANCE……………………
MODEL NO…………………………………………..
SERIAL NO………………………………………….

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>