HOOVER CH50300 Prime Lite Lightweight Commercial Vacuum Cleaner User Guide

June 13, 2024
Hoover

CH50300 Prime Lite Lightweight Commercial Vacuum Cleaner
User GuideHOOVER CH50300 Prime Lite Lightweight Commercial Vacuum
Cleaner Prime Lite™
Quick Start Guide
LIGHTWEIGHT COMMERCIAL
VACUUM CLEANER
For use with model CH50300

CH50300 Prime Lite Lightweight Commercial Vacuum Cleaner

WARNING: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt whether the outlet is properly grounded. Do not modify the plug provided with the appliance- if it will not fit the outlet, have a proper outlet installed by a qualified electrician. When using an electrical appliance, basic precautions should always be followed to reduce risk of fire, electric shock or injury.

ASSEMBLY

  1. Remove the two screws from the connector assembly. Remove plastic insert by pulling upward.
    HOOVER CH50300 Prime Lite Lightweight Commercial Vacuum Cleaner - ASSEMBLY
1

  2. With ON/OFF switch facing the front, slide upper handle section over matching section of the connector assembly. Hold handle brace against upper handle and aligscrew holes. Insert one screw into top hole and one screw into the bottom hole, then tighten firmly until handle is no longer loose.HOOVER CH50300 Prime Lite Lightweight Commercial Vacuum Cleaner - ASSEMBLY 2

REPLACING THE BAG

WARNING: To reduce the risk of injury from moving parts- Unplug before cleaning or servicing.

All paper dust bags are NOT the same. Your Hoover® Commercial disposable dust bags have been designed to be used with the Hoover® cleaner. Using bags other than genuine Hoover® Commercial disposable bags will affect the cleaning ability of your cleaner and could cause damage to it.
Available replacement bag model numbers that work with this vacuum
MODEL NO. AH10300

  1. Unzip outer bag and remove filled bag.
    Hook bottom of bag collar opening under lip “B” of connector assembly. Pull up on bag collar and snap over lip “A” of connector.HOOVER CH50300 Prime Lite
Lightweight Commercial Vacuum Cleaner - ASSEMBLY 3

  2. Press on edges of bag collar to insure bag is completely installed.
    IMPORTANT: Make sure bag collar is behind lips “A” and “B”. If it is not, dust will leak into outer bag. When filter bag is in place, close outer bag with zipper fastener.HOOVER CH50300 Prime Lite Lightweight Commercial Vacuum
Cleaner - ASSEMBLY 4

Hoover.com
HooverCommercial.com
©2023 Techtronic Floor Care Technology Limited
Dial: 1-888-768-2014 (M-F 8AM – 4:30 PM EST)
to speak with a Customer Representative.
964A00291-R0

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals