cocoon IT315007 Voyager Quadcopter User Guide

June 12, 2024
COCOON

cocoon logo IT315007
Voyager Quadcopter
Getting Started Guide

UNPACK

Unpack the Cocoon Voyager Quadcopter from the packaging and check you have all the components:

• 1 x Voyager Quadcopter
• 1 x Remote Control
• 4 x Replacement Propellor Blades
• 4 x Blade Guards
• 1 x Screwdriver| • 1 x USB Charging Cable
• 4 x ActivEnergy AA Batteries
• 1 x Instruction Manual
• 1 x Getting Started Guide
• 1 x Warranty Card
---|---

cocoon IT315007 Voyager Quadcopter - UNPACK

CHARGE BATTERY

  1. Switch the Voyager Quadcopter off and open the battery cover.
  2. Pull the battery wire out of the power port and remove battery.
  3. Plug the battery wire into the smaller end of the USB charging cable.
  4. Connect USB cable to an active USB port.

Note: A full charge will take roughly 75 minutescocoon IT315007 Voyager
Quadcopter - CHARGE BATTERY

INSERT BATTERIES

  1. Remove the screw from the back of the remote control and remove the battery cover.
  2. Insert 4 x AA batteries (taking note of polarity) and replace battery cover.
  3. Reverse the steps in Section 2 to reconnect the battery to the Voyager Quadcopter.

cocoon IT315007 Voyager Quadcopter - BATTERIES

TURN ON THE VOYAGER QUADCOPTER AND PAIR REMOTE CONTROL

  1. Set the switch on the Voyager Quadcopter to “On” and place it on a flat, horizontal surface.
  2. On the remote control, set the power switch on the front to the “On” position.
  3. Push the left control stick to the highest position until you hear the remote control beep, then pull down to the lowest position until you hear another beep.

Note: When successfully paired, the lights on the Voyager Quadcopter will stop flashing and change to solid colours![cocoon IT315007 Voyager Quadcopter

FLY

Note: Incorrect operation of this Voyager Quadcopter may result in severe injury, loss of property or fines.
Winplus Australasia does not take any responsibility if local rules and regulations are not followed.
Note: The best way to know which direction the Voyager quadcopter is facing is by the coloured LEDs on it’s wings. The red lights will face forwards, while the green lights face backwards. Always keep the Voyager Quadcopter in direct line of sight.

cocoon IT315007 Voyager Quadcopter - Hover up and downHover up and down
Push the left control stick up or down.
The Voyager Quadcopter will fly upward or downward.cocoon IT315007 Voyager
Quadcopter - Turn left and rightTurn left and right
Push the left control stick left or right.
The Voyager Quadcopter will turn left or right.cocoon IT315007 Voyager
Quadcopter - Forward and backwardForward and backward
Push the right control stick up or down. The Voyager Quadcopter will fly forward or backward.cocoon IT315007 Voyager Quadcopter - Sideward
flySideward fly
Push the right control stick left or right.
The Voyager Quadcopter will fly left or right.

FURTHER INSTRUCTIONS

For further flying instructions, as well as advanced techniques, please refer to the instruction manual provided.

After Sales Support
1300 663 907
www.winplus.com.au

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals