InnovaGoods V0103326 LED Mini Sewing Machine User Manual

June 12, 2024
InnovaGoods

InnovaGoods V0103326 LED Mini Sewing Machine User Manual
InnovaGoods V0103326 LED Mini Sewing Machine

TECHNICAL SPECIFICATIONS

  • Works with 4 1.5 V AA batteries
  • Works with a DC 6 V / 1 A power adaptor
  • Led light + Thread cutter (In reference V0103326)

CONTENTS

  • 1 Mini Sewing Machine InnovaGoods®
  • 4 cotton reels
  • 1 foot pedal
  • 1 power adaptor
  • 1 detachable rewind shaft
  • 1 threader

PIECES

  1. On/off switch
  2. Speed switch
  3. Wheel
  4. Spindle
  5. Upper bobbin
  6. Thread guides
  7. Spring
  8. Lever
  9. Needle fastening screw
  10. Presser foot
  11. Lower compartment
  12. Lower bobbin
  13. Presser foot lever
  14. Button for opening the compartment
  15. Hole for the rewind shaft
  16. Power point of the pedal
  17. AC/CC power outlet

INSTRUCTIONS

  1. Raise the needle manually using the wheel.
  2. Upper thread: pass the thread of the spindle or the upper bobbin through the spring between the thread guides, the lever, the two lower thread guides and the needle.
  3. Lower thread: open the lower compartment, place inside the compartment and leave out a strip of thread of 5 cm. Close the lid. Turn the wheel to adjust the thread.
  4. Raise the presser foot using the lever, position the fabric and lower the presser foot.
  5. Spin the wheel two or three times to check the movement of the fabric, select the speed of the Mini Sewing Machine InnovaGoods® and start sewing.
  6. Even out the stitch adjusting the lower and upper threads so that the stitches are identical.
  7. When you have finished sewing, turn off the switch and manually spin the wheel to raise the needle. Raise the lever of the presser foot to remove the fabric and release the thread.
  8. To rewind a bobbin, place the shaft in the hole of the wheel and spin it counterclockwise. Insert the empty bobbin, wind a little thread around it and turn on the switch.
  9. To change the needle in case of breaking, unplug the Mini Sewing Machine InnovaGoods®, turn the wheel until the needle is completely raised, unscrew the fastening screw and change it. Insert a new needle and tighten the screw again.

WARNINGS

Make sure that the Mini Sewing Machine InnovaGoods® is unplugged when threading the needle and carrying out cleaning or maintenance tasks. Replace the batteries if you notice that the Mini Sewing Machine InnovaGoods® slows down its functioning. Do not mix new and used batteries in the compartment. If you are not going to use the unit for a long period of time, remove the battery. Use the appliance on a flat, stable surface. Do not expose batteries to high temperature or direct sunlight. Do not attempt to open them. do not dispose of them in fire, there is risk of explosion. Make sure that the voltage of the power source corresponds to that of the appliance. Unplug the appliance whenever you are not using it.

Do not pull on the cable and ensure it does not tangle. Keep the cable away from hot and sharp surfaces. Before cleaning, make sure that appliance is disconnected from the power supply and has cooled completely.

Clean with a damp cloth. Do not use abrasive products for cleaning. Do not immerse the appliance or cable in liquid. Do not handle it with wet hands Do not use near water or damp areas. Suitable for domestic use only.

Use the device for its intended purpose only. Store the device in a dry, dust- free place. Do not leave the appliance unsupervised when it is turned on. This appliance is not a toy. Keep out of reach of children. Do not modify the appliance or any of its components. If the appliance, the cable or the pieces looked damaged or do not work correctly, do not use them or attempt to repair them; they should only be repaired by a qualified technician.

This device is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are supervised by an adult responsible for their safety. This device is not household waste. Please follow the environmental regulations in place for its recycling

V0103326
IMPORTED BY RSVIP S.L., B87646477
DISTRIBUTED BY: NNI S.L., B98019235
C/ENGUERA. 46018, VALENCIA, SPAIN.
© BY INNOVAGOODS®.
ALL RIGHTS RESERVED. MADE IN P.R.C

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals