TECHTOP MWS-180 Screen User Manual

TECHTOP MWS-180 Screen

SAFETY INSTRUCTIONS

CAUTION!
Keep this device away from rain and moisture!
For your own safety, please read this user manual carefully before you initial start-up. Operations:

1. Description of the fixture

2. Installing
   Moving Parts of the drive must be installed higher than 2,5 mm above the floor or other level that could provide access to it. Choose a suitable place for installation.it is best to install two screws on the wall, the distance of the screwsust be equal to that of the two rings and they should be at the same level, the rings must be strong enough to load more than 25kg weights.

3. USEFUL INSTRUCTIONS
   Hold the pulling ring tightly and pull down the screen slowly, then stop when the black border comes out(or stop pulling where you want to stop), the screen can be auto-fixed, if it can not be fixed, please operate it once again according to the same method. After using. release the screen and it will go up and back to the housing.

WARNINGS

1. The screen can not be folded. Do not use fingers or hard objects to touch the screen surface. Do not splash the milk, fruit juice, or other chemical doses on the screen surface. Keep the screen far away from the high temperature objects or fire.
2. If the screen is dirty wash the screen gently by a broom or a cotton ball do not use the organic solvents to clean the screen surface.
3. When pulling the screen down, must be slowly and vertical. Do not pull it roughly, please stop pulling as soon as the black border is out or the screen is jammed or injured, then send the screen to the maintenance center.
4. After using, put the Screen back to the housing in order to avoid being polluted, If not using it for a long time, please take the screen from the wall and pack it in a carton.

Technical data

1. Matte White Screen
   • Gain: 1.1
   • Viewing Angle: 160
   • High color rendering, high resolution.
2. Glass Beaded Screen
   • Gain: 2.5
   • Viewing Angle: 60
   • High color rendering, high resolution.
3. High quality synchronous or tubular motor is equipped in the left end of the screen housing.
4. Gain Measurement: refer to the fig below
   • Standard: JB/T8389 issued by the Ministry of Machinery Industry
5. Viewing Angle Measurement: refer to the fig below
   • Standard: JB/T8389 issued by the Ministry of Machinery Industry

Specifications

• MWS-180/Atlastand: operating manually
• 1800*1800mm
• 1:1,diagonal:100 inch
• slow rising
• metal housing, white plastic material
• Net weight: 7.0kgs
• Dimensions:1961011cm(L W D)

Please note: Every information is subject to change without prior notice.

Documents / Resources

| TECHTOP MWS-180 Screen [pdf] User Manual
MWS-180, Screen, MWS-180 Screen
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>