xpr MTPX-OSDP-EH CSN Reader with OSDP Interface Instruction Manual
- June 12, 2024
- xpr
Table of Contents
xpr MTPX-OSDP-EH CSN Reader with OSDP Interface Instruction Manual
SPECIFICATIONS
Technology: Proximity (125 KHz)
Interface: RS-485, OSDP compatible
Supported credentials: EM4100, HID Compatible
Read range: Up to 6 cm
Power supply: 9 – 14 VDC, 110mA
Sound Indicator : Internal buzzer
LED Indicators: Red, Green and Orange (Red + Green)
Environmental rating: Outdoor, IP65
Operating humidity: 5% – 95% relative humidity, non-condensing
Operating temperature: -20°C to 50°C
Mounting: Surface mount
Panel connection : Cable 0.5 m
Dimensions (mm): 92 x 51 x 27
MOUNTING
-
-
3 (3 x 30mm)
-
1 (M3 x 6mm)
Rubber gasket
Front
Back
Mounting base (optional
WIRING
RS-485 bus termination
120 ohm OFF
2-OFF
120 ohm ON
2-ON
Ferrite Core
Wrap the wires around the ferrite core (1 turn). The ferrite core is provided
with the kit and it is used to reduce the EMI
Connection reader to OSDP controller
Recommended cabling:
Multiconductor cable 2 twisted pair with shielding .Max length: up to
1200m.The cable shielding will be connected to the fixing clamp of the access
unit.
PROGRAMING AND SETTINGS
Procedure for SCBK (Secure key for OSDP communication) Reset: Power the reader. Set DIP Switch 1 to ON and in the less than 5 sec set it back to OFF position.
VISUAL AND AUDIO SIGNALIZATION
All signalization is managed by the OSDP controller except: Reader OFF Line: Red blinking LED.
SOFTWARE SETTINGS
XPR Toolbox is software for settings and firmware update of the reader. Reader is ready to be used “out of the box”, so is not required to be configured by the software. XPR Toolbox can be downloaded from https://software.xprgroup.com/
CONNECTION TO PC
To setup the reader or update the firmware, run the XPR Toolbox and select ”OSDP Standard readers” and ”MTPX-OSDP-EH” and click on “Open” tab. Follow the instruction in the software to set up or update firmware.
This product herewith complies with requirements of EMC directive 2014/30/EU, Radio Equipment Directive 2014/53/EU. In addition it complies with RoHS2 directive EN50581:2012 and RoHS3 Directive 2015/863/EU
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>