NEXA MIMST-1703 Motion Detector Instruction Manual
- June 12, 2024
- NEXA
Table of Contents
NEXA MIMST-1703 Motion Detector Instruction Manual
MIMST-1703
RÖRELSEVAKT
För inomhusbruk
Indoor wireless motion detector that trigger your receivers on detection of
movement. Not compatible to dimmer receivers.
NOTE: Before use, the back cover must be opened and the protective strip
beneath the battery must be removed.
PROGRAMMING RECEIVERS
- Set the receiver to learning mode.
- Press the learn button once.
PROGRAMMING CONFIRMATION
If a light is connected to the receiver, this flashes twice.
DELETING A RECEIVER
- Set the receiver to learning mode.
- Press the learn button twice.
CONFIRMATION OF DELETION
If a light is connected to the receiver, this flashes twice.
INSTALLATION
- Use a cross head screwdriver to mount the magnetic base on a flat surface.
- Attach the motion sensor to the magnetic base making sure the detection lens is not upside down, see picture.
- Adjust angle.
LUX SETUP
Adjust the light sensitivity to ambient light level. The motion sensor will only trigger when the lux level is lower than the initial lux setting.
DELAY OF TIMER SETUP
Each time you trigger the receiver, the timer will start to countdown and
turns OFF the receiver once it reaches to 0 minute.
If the motion sensor detects another object during the first activation of the
timer, the timer will extent and countdown from the very last movement
detected.
INDICATION LOW BATTERY
At low battery level, red LED flashes every 4 seconds in the detection window.
TECHNICAL DATA
Safety and information
Indoor range: up to 30 m (optimal conditions). The range is strongly
dependent on local conditions, such as the presence of metals. For example,
the thin metal coating in Low-emissivity (Low-E) glass has a negative impact
on the range of radio signals.
There may be restrictions on the use of this device outside the EU. If
applicable, check whether this device complies with local directives.
Maximum load: Never connect lights or equipment that exceed the maximum load of the receiver, as it can result in defects, a short circuit or fire.
Life-support: Never use Nexa products for life-support systems or other applications in which equipment malfunctions can have life-threatening consequences.
Interference: All wireless devices may be subject to interference, which
could affect performance. The minimum distance between 2 receivers should be
at least 50 cm.
Repairing: Do not attempt to repair this product. There are no user-
serviceable parts inside.
Water-resistance: This product is not water-resistant. Keep it dry.
Moisture will corrode the inner electronics and can result in a short circuit,
defects and shock hazard.
Cleaning: Use a dry cloth to clean this product. Do not use harsh
chemicals, cleaning solvents, or strong detergents.
Environment: Do not expose the product to excessive heat or cold, as it
can damage or shorten the life of electronic circuit boards.
NEXA AB, DATAVÄGEN 37B, 436 32 ASKIM, SWEDEN
info@nexa.se | www.nexa.se
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>