WINGBO WBWL-Y031-GD Wall Sconce Rattan Wrapped Wall Lamp Instruction Manual
- June 12, 2024
- WINGBO
Table of Contents
WBWL-Y031-GD Wall Sconce Rattan Wrapped Wall Lamp
Instruction Manual
WALL LAMP
WARNING:
-
To reduce the risk of fire, electrical shock or personalinjury, always turn off light fixture and allow It to cool prior to replace the light bulb.
-
Do not touch bulb when fixture Is turned on : do not look directly at a lit bulb.
-
Keep flammable materials away from lit bulb.
-
This fixture has been rated for up to one(1) E26 Socket 60–Watt maximum standard incandescent light bulbs (not included)or CFL or LED equivalent bulbs(not included).
To avold the risk of fire—-
DO NOT EXCEED THE RECOMMENDED LAMP WATTAGE. • -
The lighting fixture ls meant for Indoor use. DRY LOCATIONS ONLY.
-
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
-
Make sure power ls completely off at the fuse box. Have your fixture installed by a qualified licensed electrician.
-
Prepare everything in clear area.
-
Wear gloves at all times during this installation.
-
Read Instructions carefully.
-
before you start assembly. Keep this Instruction sheet for future reference.
Special Note
This products can be used for two Installation methods-option 1 & option 2, this can be freely matched according to your needs.
- Remove the fixture from its original packaging and remove the fixture mounting plate from the fixture Attach the fixture mounting plate to the electrical Junction box on the wall using the two screws provided In the hardware package.
- Now attach the fixture to the mounting plate, which Is attached to the electrical Junction box on the wall.First attach all wiring with the provided marrets(whlte to whlte N ,black to black”L’,ground to ground’G’). Push the screws through the holes in the back of the fixture so they are poking through into the center of the fixture.
- Attach the lamp fitting to the mounting plate and screw by using thumb screw supplied, and be sure It Is firmly secured to the fixture (do not over tighten).
- Install the Rattan lampshade on the lamp head.
- Attach the light bulb to the socket.
You have now completed the Installation of your fixture please enjoy.
- Attach the wall bracket to the wall by using tapping screw supplied.
- then follow up the steps above(3,4,5)to complete the installation.
Thanks for your purchase!
Should you have any questions or concerns, please do not hesitate to contact
us by mail address.
Support@wingbolighting.com