WINGBO WBWL-RM18-BS-203 1-Light Bathroom Light Fixtures Wall Sconces User Manual
- June 12, 2024
- WINGBO
Table of Contents
WINGBO WBWL-RM18-BS-203 1-Light Bathroom Light Fixtures Wall Sconces
Product Information
The WBWL-RM18-BS-203 and WBWL-RM19-NI-204 are semi-flush mount lighting fixtures designed for indoor use. They are rated for up to two (2) E12 Socket 60-Watt maximum light bulbs or LED equivalent bulbs (not included). Exceeding the recommended lamp wattage may pose a risk of fire.
Product Usage Instructions
- Remove wall bracket (B) from canopy (D).
- Attach the wall bracket (B) to junction box (not included) with screws (C) supplied.
- Make electrical connections using wire nuts (A).
- Attach the canopy (D) to the wall bracket (B) and screw it by canopy nuts (D).
- Assemble the beads(F) frame to the shade.
- Connect the shade(G)and ring(H).
- Install the light bulbs (not included).
Please read the installation instructions carefully and follow each step in order to ensure proper installation and safe usage of the lighting fixture. If you have any questions or concerns, please consult a professional electrician.
SEMI-FLUSH MOUNT
WBWL-RM18-BS-203 WBWL-RM19-NI-204
WARNING:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
- Check for electric, gas, & plumbing lines before drilling or consult a professional.
- Turn off your electricity at the circuit breaker or main fuse box before installation.
- Do not restore power to the line until fully installed.
- Do not exceed the recommended wattage.
- Always allow bulbs to cool for 10 minutes before changing.
This fixture has been rated for up to two (2) E12 Socket 60 -Watt maximum light bulbs or LED equivalent bulbs (not included). To avoid the risk of fire, DO NOT EXCEED THE RECOMMENDED LAMP WATTAGE. The lighting fixture is meant for indoor use.
Installation
Please read the installation instructions carefully and follow the steps:
- Remove wall bracket (B) from canopy (D). Then attach the wall bracket (B) to junction box (not included) with screws (C) supplied.
- Make electrical connections using wire nuts (A).
- Attach the canopy (D) to the wall bracket (B) and screw it by canopy nuts (D).
- Assemble the beads(F) frame to the shade
- Connect the shade(G)and ring(H).
- Install the light bulbs (not included).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>