WINGBO WBWL-GL07-CH Light Nickel Wall Sconces Glass Wall Lamp Lighting Fixtures Instruction Manual
- October 30, 2023
- WINGBO
Table of Contents
WINGBO WBWL-GL07-CH Light Nickel Wall Sconces Glass Wall Lamp Lighting
Fixtures
Product Information
The lighting fixture is rated for indoor use only. It is designed to hold up to one (1) E12 Socket 40-Watt maximum light bulb or LED equivalent bulbs (not included). The fixture should not be used with bulbs exceeding the recommended wattage. The assembly instructions must be followed carefully to ensure safe installation.
Product Usage Instructions
- Before beginning installation, turn off the electricity at the circuit breaker or fuse box to reduce the risk of electric shock.
- Take the wall bracket off the canopy and connect it to your junction box (not included) using the provided screws.
- Make electrical connections using the wire nuts.
- Place the canopy against the mounting surface while being careful that no wiring is left exposed.
- Secure the canopy to the wall bracket with the 2 previously removed ball nuts.
- Install the light bulbs (not included) by following the manufacturer’s instructions. Do not exceed the recommended wattage.
- Install the shade to the socket.
- After installation, turn on the electricity supply and ensure that the light is functioning properly.
If you have any questions or concerns, please contact us at support@wingbolighting.com
ASSEMBLY INSTRUCTIONS
WARNING
- Check for electric, gas, & plumbing lines before drilling or consult a professional.
- Turn off your electricity at the circuit breaker or main fuse box before installation. Do not restore power to theline until the light has been fully installed.
- Do not use with bulbs exceeding the recommended wattage.
- Always switch off the electricity supply and allow bulbs to cool for 10 minutes before changing.
- This fixture has been rated for up to one (1) E12 Socket 40-Watt maximum light bulbs or LED equivalent bulbs (not included).
- To avoid the risk of fire, DO NOT EXCEED THE RECOMMENDED LAMP WATTAGE.
- The lighting fixture is meant for indoor use.
ASSEMBLY
Please follow the steps (1-6) to install the lighting fixture.
- To reduce the risk of electric shock, ensure electricity has been turned off at the circuit breaker or fuse box before beginning.
- Take the wall bracket off the canopy, Connect your wall bracket to your junction box (not included) using the provided screws.
- Make electrical connections using the wire nuts.
- Being careful that no wiring is left exposed, place the canopy against the mounting surface. Secure the canopy to the wall bracket with the 2 previously removed ball nuts.
- Install the light bulbs (not included).
- Install the shade to the socket.
Thanks for your purchase! Should you have any questions or concerns, please do not hesitate to contact us by mail address support@wingbolighting.com
Read User Manual Online (PDF format)
Loading......