WINGBO WBWL-S014-NW Indoor Lantern Wall Sconces Installation Guide
- June 12, 2024
- WINGBO
Table of Contents
WINGBO WBWL-S014-NW Indoor Lantern Wall Sconces
Product Information
The product is a wall lamp that comes with all the necessary parts for installation. It includes a cage (A), a backplate (D), a washer (G), a nut (H), a wrench (I), screws (E), decor nuts (C), an anchor (L), a universal plate (F), and a bulk (K). The lamp can be installed using either a plug-in or hardwired method.
Contents
Please make sure you have all the contents above when unpacking the carton
before starting the installation. Do not throw away any above parts. 
Product Usage Instructions
Plug-in Installation
- Ensure you have all the contents mentioned in the manual.
- Push B into A to form the cage.
- Attach the backplate (D) to the cage (A&B) by placing the washer (G) first and then screwing the nut (H) using the wrench (I).
- Mark the position for mounting the universal plate (F) and insert the screws (E) into the plate before mounting.
- Insert the anchor (L) into the wall and mount the wall lamp to secure it in place with the screw (M).
- Wire the black and white wires from the cage input wire to the plug’s black and white wire, ensuring black is connected to black and white is connected to white.
- Put the bulk (K) into the socket.
- Plug the lamp into a socket and turn the light on/off. If it does not light up, unplug it and check the wiring from step 3 or the bulb. Then, try turning it on/off again.
WARNING:
-
To reduce the risk of fire, electrical shock or personal injury, always turn off light fixture and allow it to cool prior to replacing the light bulb.
-
Do not touch bulb when the fixture is turned on; do not look directly at a lit bulb.
-
Keep flammable materials away from lit bulb.
-
This fixture has been rated for up to one(1)E26 Socket 40-Watt maximum standard incandescent light bulbs(not included) or CFL or 5W LED equivalent bulbs(included).
To avoid the risk of fire—- DO NOT EXCEED THE RECOMMENDED LAMP WATTAGE. -
The lighting fixture is meant for indoor use.DRY LOCATIONS ONLY.
Hardwired Installation
- Ensure you have all the contents mentioned in the manual.
- Push B into A to form the cage.
- Attach the cover (D) to the cage (A&B).
- Loosen and remove the cable from the cover for hardwired installation.
- Mount the universal plate (F) to the junction box and secure it with screws (E).
- Mount the wall lamp to the universal plate and secure it with the decor nuts (C) onto the screws.
- Turn on the light through the switch on the wall. If it does not light up, please check the wiring.
- Wire the black and white wires from the cage input wire to the supply black and white wire, ensuring black is connected to black and white is connected to white.
- Put the bulk (K) into the socket.