GENMAX GM3500iAED 3500 Watt Dual Fuel Inverter Generator Instruction Manual

GENMAX GM3500iAED 3500 Watt Dual Fuel Inverter Generator

Product Information

The product is a generator that requires a battery to function. It has a control panel and a right maintenance cover that provides access to the battery and wiring. There are two types of wiring configurations, referred to as Type 1 and Type 2. The Type 1 wiring has four positive and negative wire plugs, with some plugs already connected upon delivery. The Type 2 wiring involves connecting a single plug to another plug. The product also includes a battery prompt label that helps locate the position of the battery and determine the placement of the positive and negative wire plugs.

Product Usage Instructions

1. Locate the right maintenance cover.
2. Loosen the maintenance knob counterclockwise.
3. For Type 1 wiring:
4. Connect the plug labeled “plug 1” to the plug labeled “plug 2”. If they are not connected, make sure to connect them.
5. Open the right maintenance cover to find the battery cable located in the lower left corner, next to the empty filter.
6. For Type 2 wiring:
7. Connect the plug labeled “plug 1” to the plug labeled “plug 2”.
8. Organize the wiring harness and secure it in place.
9. Insert the support lug under the cover plate into the slot of the generator housing.
10. Close the cover plate.
11. Tighten the maintenance knob clockwise.

Please note that the illustrations in the user manual may not exactly match the actual product due to continuous product improvement.

CONNECT THE BATTERY CABLE

How to find the location of the battery positive and negative wire plug?
Open the right maintenance cover to view the battery position. Or use the battery prompt label to determine which side of the battery positive and negative wire plugs are on.

1. Loosen the maintenance knob counterclockwise.

2. Open the right maintenance cover and the battery cable is in the lower left corner (next to the empty filter).

3. Connect the positive and negative battery wires: Due to the upgrade of the technology, you may encounter one of the following two types of wiring.

4. Type 1
   There are four positive and negative wire plugs, and the plug ① and plug ② have been connected when the generator is delivered.
   Connect the plug ③ to the plug ④. (Tip: If the plug ① and plug ② are not connected, also connect them.)

5. Type 2
   Connect the plug ① to the plug ②.

6. Organize the wiring harness and put it back in place.

7. Put the support lug under the cover plate into the slot of the generator housing and close the cover plate.

8. Tighten the maintenance knob clockwise.

STATEMENT
Due to our continuous improvement of our products, the above illustrations may not match the actual situation, and the illustrations used are only representative reference views.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>