myStrom WG 602530 WiFi Button Max Instructions
- June 12, 2024
- myStrom
Table of Contents
WG 602530 WiFi Button Max Instructions
Important safety instructions
It is important to read and understand the following safety instructions
before operating the WiFi Button.
– The WiFi Button should only be used in a dry place.
– Only use the WiFi Button in rooms where the temperature is between 0 and
40°C.
– Do not use the WiFi Button in bathrooms.
– The WiFi Button must not be opened by unqualified personnel. There are no
parts inside the adapter that can be repaired by a layperson.
– Under no circumstances should the WiFi Button come into contact with water
or other liquids.
– Do not expose the WiFi Button to direct sunlight.
Battery in this device: WG 602530 / 3.7V / 400mAh / Li-Po
The battery and the device must be disposed of separately.
To do this, open the device by pressing both halves apart and disconnect the
battery from the electronics.
Replacement of the battery with an incorrect type that can defeat a
safeguard/fuse (for example in case of some lithium battery types).
Disposal of the battery into fire or a hot oven, or mechanically crushing or
cutting of the battery may result in an explosion.
Leaving the battery in an extremely high temperature surrounding environment
that may result in an explosion or leakage of flammable liquid or gas.
Leaving the battery subjected to extremely low air pressure may result in an
explosion or leakage of flammable liquid or gas.
CE Declaration of Conformity
Ittigen, April 2023 – Hereby myStrom AG
declares that the product stated below is in compliance with the essential
requirements and other relevant provisions of the following Directives:
RED Directive 2014/53/EU
Product Name – WiFi Button Max
Part Number – WBM1
The product to which this declaration relates is in conformity with the
following standards and Implementing Measures:
Safety · EN 60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013
EMC · EN 301 489-1 V2.1.1 · EN 301 489-17 V3.1.1 · EN 62479
Radio · EN 300 328 V2.1.1
The following importer is responsible for this declaration
Company Name and Address
Mystrom AG · c/o tiko Energy Solutions AG · Pflanzschulstrasse 7
8004 Zürich · Switzerland
Person responsible for this declaration
Tom Kienle
Chief Executive Officer
The following manufacturer is responsible for this declaration
Company Name and Address
Mystrom AG · c/o tiko Energy Solutions AG · Pflanzschulstrasse 7
8004 Zürich · Switzerland
Person responsible for this declaration
Tom Kienle
Chief Executive Officer