myStrom WG552535P WiFi Button Max Instruction Manual
- June 13, 2024
- myStrom
Table of Contents
myStrom WG552535P WiFi Button Max
Installation
Download the myStrom app
Launch app
Open a free account or connect with your existing one.
Add WiFi Button
Select «Add device» in the menu to add your new WiFi Button.
All Done
The battery in this device: WG 552535P / 3.7V / 450mAh / Li-Po The battery and the device must be disposed of separately. To do this, open the device by pressing both halves apart and disconnecting the battery from the electronics.
Button, LED, Modes, Reset
LED
Reset
Push the top right button for 10 seconds > it will blink white/red > release your finger > within 5 seconds, push it again, once > it will blink 10x white – this will reset the WiFi Button to its factory settings. The connection to your WiFi network is lost.
FAQ & Support
Recharge the built-in battery – with the USB cable.
The WiFi Button is not working?
Place it close to your DSL Router Re-connect the WIFI Button – reset it. The
Button is now in WPS Mode for 2 minutes. Push the WPS button on your router.
If the Button blinks 3x in green, it has reconnected. If it blinks 3x in red –
please repeat the Reset procedure myStrom AG c/o tiko Energy Solutions AG
Switzerland mystrom.com