WYZE Battery Cam Pro Outdoor Smart Camera User Guide

June 12, 2024
Wyze

WYZE Battery Cam Pro Outdoor Smart Camera

WYZE-Battery-Cam-Pro-Outdoor-Smart-Camera-product

WYZE Battery Cam Pro Outdoor Smart Camera

IN THE BOX

  • Wyze Battery Cam Pro × 1
  • Battery Pack × 1
  • Wall Mount × 1
  • USB Cable × 1
  • Screw Assembly × 1
  • Silica Gel Desiccant × 1
  • Quick Start Guide × 1

Read this manual carefully and save it for future reference.

Disclaimer: The products, accessories, user interfaces, etc. illustrated in this guide are intended for reference only. Due to product updates, the actual product and the illustrations in this guide may vary.

OVERVIEW

WYZE-Battery-Cam-Pro-Outdoor-Smart-Camera-fig-3

SETUP

  1. Download the Wyze app and sign in or create an account.
  2. Open the Wyze app and tap the + sign in the top left corner of the Home tab.
    • Follow the in-app instructions to set up the camera.
  3. Follow along in the app to mount the camera.

WALL MOUNT

  1. Rotate the wall mount base clockwise.
  2. Locate the positions of the holes and drill holes on the wall.WYZE-Battery-Cam-Pro-Outdoor-Smart-Camera-fig-5
  3. Insert the drywall anchor into the hole.
  4. Screw the base into the drywall anchor.
  5. Screw the wall mount into the back of your Wyze Battery Cam Pro.

CONNECT USB CABLE

STATUS LIGHT GUIDE

  • Solid yellow light

    • The device is powered on and initializing
  • Flashing yellow and blue lights

    • The device is ready for pairing
  • Solid blue light

    • Pairing successful
  • Solid red light

    • The device is connected
  • Quickly flashing red light

    • Battery level is at 0%
  • Flashing green light

    • The device is charging
  • Solid green light

    • The battery is full
  • No indicator light

    • The device is powered off or asleep

PRECAUTIONS

  • Prolonged direct sunlight can heat the inside of your camera past its maximum operating temperature of 122°F (50°C). Avoid direct sunlight where possible and only use your camera in environments within its operating temperature range: -4 to 122°F (-20° to 50°C).
  • To charge your camera, plug the included micro USB cable into the USB port on your base station and connect it to your camera. This product is intended to be supplied by a UL Listed power adapter marked “LPS” (Limited Power Source) and rated with an output of 5Vdc, 2A minimum, Tma = 50°C minimum.
  • If powered by a power adapter with ground pin, the adapter should be properly grounded.

CAUTION: Risk of fire or explosion if the battery is replaced by an incorrect type.

  • Replacement of a battery with an incorrect type that can defeat a safeguard (for example, in the case of some lithium battery types);
  • Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
  • Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; and
  • A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
  • Where applicable, antenna types), antenna models(s), and worst-case tilt angles) necessary to remain compliant with the eirp. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated.

FCC STATEMENT

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.

FCC RADIATION EXPOSURE STATEMENT

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

ISED RSS WARNING

This device contains licence-exempt transmitters) / receivers) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSSs). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

ISED RADIATION EXPOSURE STATEMENT

This equipment complies with ISED R radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. Only use the power supply provided. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

WARRANTY

Apple logo and App Store are trademarks of Apple Inc., registered in the U.S. and other countries and regions.
Google Assistant, Google Home, Google Play, and the Google Play logo are trademarks of Google LLC.

For product available in the USA/Canada market, only channel 1-11 can be operated. Selection of other channels is not possible.

NEED HELP

Scan the QR code to learn more

Wyze and Wyze Battery Cam Pro are trademarks of Wyze Labs, Inc.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals