Bodet IK10 Protective Accessories for Style Clocks Instruction Manual
- June 12, 2024
- Bodet
Table of Contents
Bodet IK10 Protective Accessories for Style Clocks Instruction Manual
Safety information
We recommend that you read this manual carefully before installing the product. Failure to observe these instructions may cause irreversible damage and invalidate the warranty. BODET shall not be responsible for any damage arising due to non-observance of these instructions. Identification of pictograms:
| Symbol | Description |
|---|---|
| IEC60417 – 1641 |
Operating instructions
| | IEC60417 – 0434b
Caution
Mechanical installation
The protective accessory must be attached after the clock has been installed.
Position and centre the protective accessory on the clock to easily determine
the location of the holes to be drilled. Refer to the centre distances if
necessary. Screws included (TORX P). Wall plugs not included, to be chosen
according to the type of wall. Tighten moderately so as not to damage the
protective accessory.
- 946 040
IK10 Protective casing for Style 5
- 946 030
IK10 Protective glass for Style 5 recess mounted
- 946 031
IK10 Protective glass for Style 7D recess mounted
Cleaning
Soapy water. Do not use thinner products.