T nB UMTYREFL10 Solid 10 Inch Tyre for E-Scooter Instructions
- June 4, 2024
- T-nB
Table of Contents
T nB UMTYREFL10 Solid 10 Inch Tyre for E-Scooter
Congratulations on your purchase and thank you for your trust and confidence in TnB. Our products comply with the regulations and standards in force. Before using this device, we recommend that you read the instructions and safety guidelines carefully and keep this manual for future reference.
Material needed
cutter, Phillips screwdriver, Allen key, lubricant or liquid soap, 3 tire levers, 2 clamps
-
Use the cutter to remove the red adhesive part. Use a Phillips screwdriver to loosen the screws.
-
Remove the plastic guard and unthread the central bolt using an Allen key. Perform these operations on both sides of the wheel.
-
Remove the wheel from its place. For the front wheel, pull the brake cable and be careful not to damage it. For the rear wheel, unscrew the 5 screws with a Phillips screwdriver and remove the disc.
-
Unscrew the valve and push it lightly with a screwdriver.
-
At this point, apply lubricant or liquid soap on the inner edges of the tire for easy handling. If you are unable to do as above, the following steps are still possible.
-
Place 2 tire levers on either side of the valve. Leverage to remove the tire from the rim, then repeat this operation around the wheel.
-
Extract the tire and the inner tube from the rim, taking care to loosen the valve.
-
Lubricate the inside of the tire to facilitate the following operations.
-
Using a tire lever, position the tire on the first part of the rim.
-
Use two clamps to clamp the tire on both sides of the valve.
-
Place two tire levers opposite the clamps, then leverage with a third tire lever between the two already installed.
-
Remove the tire levers and the clamps.
-
For the rear wheel, tighten the 5 brake disc screws.
-
Replace the wheel in its location and screw in the bolts on both sides. For the front wheel, remember to reinsert the brake cable in its notch so that it doesn’t protrude from the fork.
-
Screw the plastic guard in place and reposition the red sticker.
NEED HELP?
- Concerned about the satisfaction of our customers, you can contact us at info@t-nb.com
- For maintenance, troubleshooting, and miscellaneous information about this product, please visit our
- website: www.t-nb.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>