Coralme motor Y06 Helmet Wireless Headset User Guide
- June 13, 2024
- Coralme motor
Table of Contents
Coralme motor Y06 Helmet Wireless Headset User Guide
Product overview
Important Notice:
Before installing the headphones, follow the Quick Manual instructions to
connect your phone and listen to the sound and volume. If there is a large
difference in sound effect and volume after installing it on the helmet,
please adjust the position of the speaker in the helmet.
Power on/off
Power on
Double-click the button to switch the Chinese and English voice broadcast
(Disconnect Bluetooth)
Press and hold for 3 seconds to turn on the device.
Power-on tone
The LED light flashes quickly
Power off
Press and hold for 3 seconds to turn on the device
Power-on tone
The LED light goes out
Pairing
Bluetooth waiting pairing status:
The work indicator flashes quickly
Bluetooth mode
tone Bluetooth pairing successful:
The work indicator flashes slowly
Phone features
Double-click to toggle manual auto answering
(When Bluetooth is not connected)
( automatic (After 10 seconds)
Power-on tone
Answer
Manually answer “short press”
Answer
(Incoming call)
Press and hold for 2 seconds
(Incoming call)
Refusal to answer
“Short press” while on a call
(On a call)
End the call
Double-click
Last-code replay
Short press
(When the call goes on)
Cancel outgoing calls
Charging mode
The red light keeps on, when charging
If you plug in the charger, the device will shut down automatically when the device is turned on
Full lights out
Music features
(music stops)
Short Press
Play
(music playing)
Pause
Volume down button
(music playing)
Short press for previous song
(music playing)
Long press to reduce the volume
Volume up button
(music playing)
Short press for next song
(music playing)
Long press to increase the volume
voice assistant
Voice Assistant button
Double-click
Wake up voice assistant
List of items
Y06 Host*1
Speaker microphone*1
Clip-on base*1
Type-C charging cable*1
Instruction manual*1
Notes
- Do not put the product into the open flame to avoid explosion;
- Do not disassemble the product. Avoid damage to product electronics;
- Do not approach the sharp object, the object will cause damage to the product; 4. Do not use for a long time, please place in a dry place.
instruction warning
NOTE: This equipment has been tested and found to comply with the limits
for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions may cause harmful interference to radio communications. However,
there is no quarantine that interference wil not occur in a particular
installation. if this equipment does cause harmful interference to radio or
television reception. which can be
determined by taming the equipment offend on, the user is encouraged totry to
correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and rereiver.
- Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.
- this device may not cause harmful interference. and
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>