Bebe Stars 960 Booster Petrol Car Seat User Manual
- June 13, 2024
- Bebe Stars
Table of Contents
960 Booster Petrol Car Seat
User Manual
USER’S MANUAL
960 Booster Petrol Car Seat
Booster
Item 960 (BAB002)
Your child’s safety depends on you. Proper product’s use cannot be assured
unless you follow these instruc
DO NOT USE THIS PRODUCT BEFORE YOU READ AND UNDERSTAND THESE INSTRUCTIONS
PARTS LIST
- Belt guidance
- Cushion with so cover
- Connector
- Belt
- Belt lock
INSTRUCTIONS FOR USE
-
Install posit in the vehicle
-
Position of the bucket
-
How to connect the Belt to the booster
INSTALLATION
SAFETY INSTRUCTIONS
Thank you for purchasing this booster car seat by Bebe Stars. We will always
give you the best products and services!
Please read this instrucarefully before you use!
The correct fiof the 3-point vehicle belt is of vital importance for the safety
of your child.
We advise you strongly not to use an unlicensed or modified or without
manufacturer’s instrucproduct, it is very dangerous. We, also, advise you
strongly not to use a second-hand product, because you are not sure what has
happened to it.
The straps holding the restraint to the vehicle should be t, any straps
restraining the child should be adjusted to the child’s body and should not be
twisted.
Make sure the lap belt is stretched as low as possible over the child’s hips.
DO NOT use any load bearing force points other than those described in the
instrucand marked in the child restraint.
For the future use of the seat, it is important that you keep the
instrucmanual carefully. If in doubt,please contact the manufacturer.
This is a “Universal” child restraint. It can be installed by Vehicle Seat
belt. It is approved to ECE R44/04, for general use in vehicles and it will fit
most, but not all car seats.
NEVER leave your child unaended in a car even for a short
DO NOT use a child safety seat that has been in a crash. A crash can cause
damage to the child safety seat that you can not see.
DO NOT modify or aempt to modify the child safety seat in any way.
DO NOT take apart or aempt to take apart this child safety seat etc.
DO NOT use a child safety seat with damaged or missing parts.
DO NOT change the cover or harness, they are the important components.
Make sure the vehicle belt is tly secured and the car seat is correctly
installed each you use it.
Car interiors can become very hot when in direct sunlight, it is recommended
that you should cover the car seat when not in use. This prevents that some
components become hot and burn the child.
Make sure that all luggage and objects likely to cause injury in the event of
an accident are properly secured.
Make sure the seat is in a safe posiDo not put any sharp or hard items around
the seat.
INSTRUCTIONS FOR USE
1.1. Install posit in the vehicle
Wrong
Correct
Only use with 3-point belt.
Do not use on front passenger seats with a front airbag!
We do not recommend installing the child safety seat in the front passenger
seat.
DO NOT use a child safety seat if the vehicle seat is equipped with front
airbags, it can be dangerous. This does not apply to so-called side airbags.
DO NOT use with 2-point belt. Please install with the 3-point belt.
ONLY use for Forward Facing.
1.2. Position of the bucket
The satisfactory position of the adult safety-belt buckle relative to the
child car seat is as the FIG. You can contact the child car seat manufacture
if in doubt about the point.
1.3. How to connect the Belt to the booster
Pull the belt one side fixed connector through one top hole of the base
(picture 1), slide the belt into the hook of the connector (see picture
2,3,4,5).
Releasing the belt is carried out in reverse order to removal.
INSTALLATION
2.1. Place the booster seat on the appropriate seat of the vehicle and push
firmly against the seat’s backrest. Ensure that the seat belt guide is
accessible and not trapped behind the booster seat.
2.2. Place the child on the booster seat and pass the seat belt under the
armrest. Diagonal belt and lap belt are all under the armrest. Lock the of the
buckle into the vehicle seat buckle with a CLICK noise. Fasten the seat belt
and pull the diagonal sect so that there is no slack lein the seat belt.
2.3. Guide the belt lock (with belt) to child shoulder on the side of car belt
automa retractor device. The belt of the belt lock system lies on the middle
of shoulder. Don’t place it too close to neck and shoulder side edge, you must
adjust the connector of the crescent belt to adjust the length of the crescent
belt and the height of belt lock.
CARE & MAINTENANCE
Periodically inspect your child seat for worn or damaged parts. If damaged
parts are found, replace the child seat. Keep the child seat clean. Do not
lubricate any parts of the child seat.
To prolong the life of your product, keep it clean and do not leave it in
direct sunlight for extended periods of
In case of light soiling, sponge the fabric cover with mild detergent and warm
water.
Also, you can removable fabric covers from the seat and hand wash them at 30
with mild detergent and warm water. Allow it to dry fully, preferably away
from direct sunlight.
Do not bleach or use chemical cleaners
Do not dry in a tumble dryer
Do not iron
Cleaning the harness and shell
Sponge clean using warm water and mild soap; do not use any other cleaning
agents.
Storage
When not in use, store in a safe, dry place and away from heat and direct
sunlight.
Avoid placing heavy objects on top of the seat.
Thank you for choosing Bebe Stars products
FOLLOW US
www.bebestars.gr
bebestarsbygilis
@bebe.stars
bebestarsbygilis
63200 | Nea Moudania | Greece
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>