Bebe Stars 419-02 Florence Multifunctional Bed User Manual

: June 12, 2024
: Bebe Stars

Table of Contents

Bebe Stars 419-02 Florence Multifunctional Bed
CARE & CLEANING
SAFETY WARNINGS
BED PARTS
ASSEMBLY
LOWERING THE RAIL
DRAWER DIMENSIONS
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Bebe Stars 419-02 Florence Multifunctional Bed

Your child’s safety depends on you. Correct assembly of the bed requires reading the manual.

Thank you for purchasing this multifunctional bed by Bebe Stars. We will always give you the best products and service.
Please read the user manual before you use!

CHANGING MAT INFO

Suitable for a child up to 12 months or a maximum weight of 11 kg
Suitable changing pad dimensions:

Length :4 7cm/Width :80cm/Height: 5cm

CARE & CLEANING

Your furniture can be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia based household polishes. Take care when handling or moving. Careless handling can damage wooden furniture.

SAFETY WARNINGS

IMPORTANT, RETAIN FOR FUTURE
REFERENCE: READ CAREFULLY
The instructions for use should be followed to the letter, so as not to reduce the level of safety of the product.
WARNING

Be aware of the risk of open fire and other sources of strong heat, such as electric bar fires, gas fires, etc. in the near vicinity of the cot.
Do not use the bed if any part is broken, torn or missing and use only spare parts approved by the manufacturer.
Do not leave anything in the bed or place it near another product, which could provide a foothold or present a danger of suffocation or strangulation, e.g. strings, blind/curtain cords.
Do not use more than one mattress on the bed.
It should not be placed too close to other furniture or windows, but almost glued to a wall or at a distance of 30cm. between the wall and one side of the bed.

WARNING! To prevent falls, the base of the mattress should be adjusted to the lowest position before the child is able to stand on his own.

The thickness of the mattress* to be used with this bed should not reduce the internal depth (from the surface of the mattress to the top of the railing) to less than 50cm. with the base in a lower position, to minimize the risk of the child jumping or falling off the crib.
The bed is intended for use by newborns. If the child can stand alone or climb out of bed, stop using it.
The bed railing can be used in 2 positions.
The mattress to be used must have dimensions proportional to the technical specifications of the manufacturer. The minimum size of the mattress must be 180x80cm. Be aware that there shall be no gap more than 30mm between the mattress and the sides end ends in any position of the mattress.
Do not use the bed before turning on and checking the locking mechanisms.
All connections must be tightened properly, checked regularly and tightened again when needed. Screws and bolts should not be loose as a child may squeeze parts of the body or climb on their clothes (eg laces, necklaces, baby doll ribbons, etc.). There is a risk of strangulation.
The bed should only be used on a dry, stable and flat surface away from electrical outlets.
If you leave the child unattended in the bed, always make sure that any folding parts of the bed are locked.
Never move the bed while the child is inside.
After assembly, do not disassemble.

Mattress not included

BED PARTS

TOOLS

ASSEMBLY

Note: If the opening between the drawers are not equal between them and/or the other panels, you can adjust this by changing the screw in the drawer conductor position as specified below.