REGENCY Equipment Stand with Undershelf Instruction Manual
- June 13, 2024
- Regency
Table of Contents
REGENCY Equipment Stand with Undershelf
Product Information
The Equipment Stand with Undershelf is a versatile and durable stand designed to provide additional storage and support for various equipment. It is constructed with high-quality stainless steel, ensuring its strength and resistance to corrosion. The stand comes with a stainless steel top, an undershelf, legs, and tightening screws. It is available in two models: a 4-leg table and a 6-leg table, each offering different load-bearing capacities.
Product Specifications:
- Model: 4-leg table / 6-leg table
- Material: Stainless steel
- Parts included:
- A (1) Stainless Steel Top
- B (1) Undershelf
- C (4) Legs (for 4-leg table) / C (6) Legs (for 6-leg table)
- D (8) Tightening Screws (for 4-leg table) / D (16) Tightening Screws (for 6-leg table)
Product Usage Instructions
- Prepare the assembly area by ensuring it is clean and on a flat secure surface.
- Carefully unpack all the contents from the box. Place the stainless steel top face down on a rug, carton, or other protected surface.
- Insert the legs into the tabletop gussets. If a leg struggles to go in, loosen the set screw before inserting.
- Partially tighten the set screws on each leg. Full tightening will be done later.
- On each leg, mark the desired height where the undershelf will be installed.
- Slide the undershelf onto the legs and fully tighten the set screws on each leg.
- Adjust the feet as needed to meet height requirements or compensate for uneven flooring.
- With assistance, carefully turn the table over and remove any protective film.
WARNING! There is a risk of personal injury due to sharp stainless steel
edges. It is advised to wear gloves during installation and handle the product
with care.
For more information, please visit
www.RegencyTablesandSinks.com
Assembly Instructions
TOOLS REQUIRED
- Allen wrench (included)
4 Leg Table
PARTS:
- (1) Stainless Steel Top
- (1) Undershelf
- (4) Legs
- (8) Tightening Screws
6 Leg Table
PARTS:
- (1) Stainless Steel Top
- (1) Undershelf
- (6) Legs
- (16) Tightening Screws
Assembly Instructions
- Make sure the assembly area is clean and on a flat secure surface. Carefully remove all the contents within the box. Place the tabletop face down on a rug, carton, or other protected surface.
- Insert the legs into the tabletop gussets. You may need to loosen the set screw if one struggles to go in.
- Partially tighten the set screws (fully tightening will come later).
- On each of the legs, mark the height where you’ll be installing the undershelf.
- Once marked, slide the shelf onto the legs and fully tighten the set screws.
- Adjust the feet as needed to meet the height requirements or to compensate for uneven flooring.
- With assistance, turn the table over and remove any protective film. The table is now ready to be used.
WARNING! Risk of personal injury. Stainless steel edges are sharp and can
cause cuts. Wear gloves during installation and handle with care.
www.RegencyTablesandSinks.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>