REGENCY onyx Fireplace Remote Control Instructions
- October 30, 2023
- Regency
Table of Contents
REGENCY onyx Fireplace Remote Control
Product Information
The remote control is a device used to control the various functions of the fireplace. It has several buttons that correspond to specific actions and settings that can be adjusted. The remote control can be used to turn on/off the fireplace, adjust flame settings, adjust glowing embers, glowing logs, downlight, sync settings, mood lighting strip, and heating settings. The remote control also has a timer function that can be set up to 10 hours.
Product Usage Instructions
- To turn on the fireplace, press the POWER button. This will turn on/off all the functions at once but will hold the settings in memory.
- To adjust flame settings, press the MY FLAME button followed by
+’ and-‘ orf’ andg’ buttons. The unit will cycle through 9 flame settings. Flames 1-6 are default settings, 7-9 can be saved as custom settings. - To enter the main flame effect adjustment screen, press the MAIN FLAME button. Press the
f’ andg’ buttons to cycle through the flame palette adjustment screen. - Press the FLAME SPEED button to enter the FLAME SPEED settings. Press the
+’ and-‘ buttons to adjust the speed by five settings. - To adjust glowing embers, glowing logs, downlight, and sync settings, press the button. Press the
f’ andg’ buttons to cycle through different settings for each function. To adjust mood lighting strip settings, press the MOOD LIGHT button. - The setting will cycle through Cold White – White – Warm White – Light Ember – Ember – Yellow – Gold Yellow – Red – Green – Cyan – Blue – Light Purple – Purple -13 Colour Cycling and Off. Press
+’ and-‘ buttons to adjust the brightness from 10-100%, total six settings including Off. - To adjust heating settings, press the HEATING button. The heater will cycle through the heat setting: AUT – LOW – HIGH – OFF. The AUTO heating will work after the weekly timer has been set in the MyFlame App.
- To set the desired time for the fireplace to run, press the TIMER button. The Timer can be set to 0.5H, 1.0H, and then each hour up to 10.0H.
- To turn on the flame effect, press the button. To turn off all the functions under the manual heating control mode, press the button. To turn off the flame effect under the AUTO heating mode, press the button.
- Ensure that the remote control is left on a flat surface in the room where the appliance is installed and away from any direct flow of hot air.
REMOTE CONTROL
The remote control should be left on a flat surface in the room where the
appliance is installed and away from any direct flow of hot air.
OPERATING THE APPLIANCE – ADVANCED OPERATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>