REGENCY ScrapLock Locking Drain Strainer Instruction Manual
- October 30, 2023
- Regency
Table of Contents
REGENCY ScrapLock Locking Drain Strainer
Product Information: ScrapLock Installation Instructions
ScrapLock is a device that is used to secure the sink drain in commercial kitchens. It uses the ring in the sink drain for a tamper-proof fit. The device comes with two feet that access the two groove openings of the ring in the standard sink drain. It also comes with a set screw and a tool to tighten the screw. The device is easy to install and comes with detailed installation instructions.
Product Usage Instructions
- Start by identifying the groove openings of the ring in the standard sink drain. Refer to Figure 1 in the user manual for assistance.
- Place the ScrapLock with the feet in the ring openings. Ensure that the guard is seated flush.
- Using the set screw as a handle, turn the guard 1/4 turn (90 degrees) to the right. This will secure the feet under the ring rim and position the set screw directly over one of the groove openings. If you are unable to turn ScrapLock during this step, loosen each foot a half-turn to extend height.
- Use the tool provided to tighten down the set screw until the top is slightly recessed into guard. This will position the set screw in the groove opening and secure the guard in place.
- Place the small plastic cap supplied into the top of the set screw head. This completes the installation process.
For more information about ScrapLock or for assistance with installation, please visit regencytablesandsinks.com
INSTALLATION INSTRUCTIONS
- The ScrapLock uses the ring in the commercial sink drain for a tamper-proof fit. Figure 1 shows the drain ring groove openings of a standard sink drain. The “feet” of Scrap-Lock access the two groove openings of the ring.
- Once ScrapLock is placed with the feet in ring openings, the guard will be seated flush. Using the set screw as a handle, TURN the guard 1/4 turn (90 degrees) to the right. This secures the feet under ring rim and positions the set screw directly over one of the groove OPENINGS.
- Use the TOOL to tighten down the set screw until the top is slightly recessed into guard. This positions the set screw in the groove opening and SECURES the guard in place.
Place small plastic cap supplied into the TOP of the set screw head. This completes the installation process.
- Note : If unable to turn ScrapLock during this step, loosen each “foot” a half-turn to extend height.
CONTENTS INCLUDE
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>