wet sounds Stealth Sound Bar ROPS Installation Guide
- June 13, 2024
- wet sounds
Table of Contents
wet sounds Stealth Sound Bar ROPS Installation
Product Information
The product being referred to in the user manual is the Wet Sounds Stealth Sound Bar, which is a sound bar designed for use with the Battle Armor ROPS (Roll Over Protection System). The sound bar provides audio entertainment while operating the mower. The hardware package includes the necessary components for installing and mounting the sound bar onto the ROPS plates. Additional hardware may also be included to compensate for any shortages in the Wet Sounds kit.
The required hardware from the Wet Sounds kit consists of:
- 2 spacers
- 2 T-nuts
- 4 8mm hex nuts
- 4 8mm lock nuts
Product Usage Instructions
- Remove the Wet Sounds sound bar from its package, along with the provided hardware.
- Slide the T-bolts into the undercuts of the sound bar.
- Install a spacer onto each T-bolt and secure them in place using one 8mm lock washer and one 8mm hex nut per T-bolt. Lock them into place approximately 12 inches apart.
- Mount the plates to the ROPS by using the provided 5/16 U-boltsand 5/16 Locking Flange Nuts through the slotted holes. Ensure that the round holes are spaced at 12 inches to accommodate the T-bolt spacing from step 3. Note that the T-bolt mounting holes should face towards the rear of the mower, i.e., the backside of the ROPS.
- The Wet Sounds Stealth bar is now ready to be mounted onto the ROPS Plates. Secure it using two 8mm lock washers and two 8mm hex nuts.
- Follow the instructions provided with the Wet Sounds Stealth Sound Bar for wiring and operation. Battle Armor recommends securing the cables to the ROPS using the included cable ties.
Wet Sounds Stealth Sound Bar ROPS Installation
Please note: Your Wet Sounds Stealth Bar comes with hardware, that may not all be needed in this application. You may find extra hardware in your Battle Armor ROPShardware package, as well, to make up for a shortage in some Wet Sound kits
- Remove Wet Sounds sound bar from package along with the hardware. Below is the hardware you will need to use from the Wet Sounds kit. 2 spacers, 2 T-nuts, (4)-8mm hex nuts and (4)-8mm lock nuts..
- Slide T-bolts into undercuts of sound bar.
- Install spacer onto T-bolts and secure T-bolts into place using (1)-8mm lock washer and (1)-8mm hex nut, per T-bolt. Lock into place approximating 12” apart.
- Mount the plates to the ROPS, using the provided 5/16” U-bolts and 5/16” Locking Flange Nuts, thru the slotted holes. Make sure the round holes are spaced at 12” to accommodate the T-bolt spacing from step 3. NOTE: T-bolt mounting holes should be towards the rear of the mower, i.e. the backside of the ROPS.
- The Wet Sounds Stealth bar is now ready to mount to the ROPS Plates. Secure with (2)- 8mm lock washers and (2)-8mm hexnuts.
- You are now ready to follow the instructions provided with the Wet Sounds Stealth Sound Bar for wiring and operation. Battle Armor recommends securing the cables to the ROPS with the included cable ties.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>