CAMPBELL HAUSFELD VT619504 Vertical Air Compressors Instruction Manual

CAMPBELL HAUSFELD VT619504 Vertical Air Compressors

Product Information

The Vertical Air Compressors are versatile and efficient machines used for various applications.

They come in different models with the following specifications:

• Model Numbers: VT619504, VT627505, VT635900, VT639000
• Dimensions: 83.82cm x 180.34cm
• Unit Weight: 115.67 kg

For parts, product, and service information, visit www.campbellhausfeld.com.

Product Usage Instructions

Before using the Vertical Air Compressor, please ensure that you have read and understood the user manual.

Follow the steps below to properly use the product:

1. Make sure the compressor is placed on a stable and level surface.
2. Check that all necessary components are securely attached and in good condition.
3. Connect the compressor to a power source using the provided motor cord.
4. Turn on the compressor by switching the power button to the “ON” position.
5. Adjust the pressure settings using the pressure switch according to your specific requirements.
6. Monitor the pressure gauge to ensure it stays within the desired range.
7. If necessary, use the drain valve to release any accumulated moisture from the tank.
8. Regularly inspect and maintain the compressor as recommended in the user manual.

If you need any replacement parts or technical assistance, please contact Campbell Hausfeld Customer Service at 1-800-543-6400.

Replacement Parts List

Description

Air compressor units are intended to provide compressed air to power pneumatic tools and operate spray guns. The pumps supplied are oil lubricated. A small amount of oil carryover is present in the compressed air stream. Applications requiring air free of oil or water should have the appropriate filter installed. The air compressor unit must be mounted as described in the instructions on a solid floor. Any other use of these units will void the warranty and the manufacturer will not be responsible for problems or damages resulting from such misuse.

Specifications

• Motor HP ……………….3.2
• Delivery CFM ……. 10.2 @ 90 psi
• Max pressure ………… 135 psi
• Pump RPM …………….1100
• Volts …………………. 240
• Phase…………………… 1
• Amp draw………………15.0
• Max duty cycle …… 75/25
• On/Off Tank outlet ………3/4in.
• (F) NPT Tank capacity ………. 60-gallon
• Dimensions ….29in. x 33in. x 71in.
• Unit weight ………….255 lbs.

When contacting them, provide the following information:

• Model number
• Serial number (if any)
• Part description and number as shown in the parts list

Address any correspondence to:

• Campbell Hausfeld
• Attn: Customer Service
• 100 Production Drive
• Harrison, OH 45030 U.S.A.

PLASTIC GUARD

Replacement Parts List

For any correspondence, address it to:

Campbell Hausfeld
Attn: Customer Service
100 Production Drive
Harrison, OH 45030
U.S.A.

For parts, product & service information visit www.campbellhausfeld.com
© 2014 Campbell Hausfeld
www.campbellhausfeld.com

References

• You are being redirected...

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>