Outwell 5709388126665 Seam Grip Wp Instructions
- June 13, 2024
- Outwell
Table of Contents
SEAM GRIP + WP™
In cooperation with
Instructions
INSTRUCTIONS
Concentrated Formula! Seals and repairs in one application.
Directions – Seam Sealing: CLEAN surfaces with alcohol. APPLY Seam Grip+ WP to
inside of seam. Apply thin film, holding tube opening flat against seam.
Lightly squeeze and draw tube across threads. Seam Grip+ WP may also be
applied with brush. Use brush to even out any heavily coated areas.
Holes and Tears: Create backing with removable tape. Fill void and 6 mm
beyond edge with a thick layer of Seam Grip+ WP. Remove tape after full cure.
LET DRY overnight (approximately 12 hours – may be longer in low humidity).
For 2-4 hour dry time, mix small batches of Seam Grip+ WP with GA Cure
Accelerator+ X. Apply with brush. Mix new batches as needed. To remove Seam
Grip+ WP from hands, buff with terry cloth soaked in isopropyl alcohol.
Storage: Once opened, Seam Grip+ WP will cure in tube if not stored properly.
Avoid contact with moisture. Advance contents to tube neck. Wipe clean and
cap. Store in cool dry place. To extend use life, place tube in a closed
plastic bag in freezer. Heat to room temperature six hours before use. During
cold weather unopened Seam Grip+ WP will harden in the tube.
Note: Fully-cured Seam Grip+ WP may cling to itself when folded. After
first application, lightly dust fully-cured areas with talcum powder. Seam
Grip+ WP is not suitable for use on Sil-Nylon (silicon based) tent fabrics
etc. To seal the seams on Sil-Nylon fabrics use GA Seam Grip+ SIL.
REPAIR TIPS & TRICKS
Seam Grip+ WP urethane rubber adhesive provides a clear, strong and flexible finish suitable for permanent waterproof repairs to holes, tears or leaking seams in most types of camping or outdoor equipment i.e. tents, marquees, awnings, ground sheets, backpacks, footwear, gloves, inflatable mattresses or toys, bladders, ski wear and other waterproof clothing, latex neck and wrist seals and kites etc.
After years of service, seam tape on tents and outerwear can peel or pucker and the seam will begin to leak. If a small section has peeled use Seam Grip+ WP to reattach it. If the tape seems to be failing everywhere, remove the tape and discard it, then clean the seams with Isopropyl alcohol and reseal with Seam Grip+ WP. Before repacking the tent and to prevent tacking, sprinkle talcum powder onto allured Seam Grip+ WP treated seams or repairs etc. Apply Seam Grip+ WP to the inside of the perimeter floor seam. This seam is not taped at the factory. Draw seam sealer across threads and under folds. To ensure Seam Grip+ WP does not run, apply a thin layer and when possible apply and allow to dry on a level surface area.
Use Seam Grip+ WP to seal areas that regularly leak, such as stakeout points
at corners. If extra strength repairs are required, once cured apply an
additional layer of Seam Grip+ WP on top of the original Seam Grip+ WP repair.
To seal the seams on your flysheet, set it up inside-out for easier
application. Attach the flysheet to the tent so all seams are taut.
Seam Grip+ WP permanently repairs common pinholes and tears in the tent floor.
Apply just enough Seam Grip+ WP to cover the hole and spread 6 mm beyond.
Allow to dry level overnight. For 2-4 hour cure time, mix Seam Grip+ WP with
GA Cure Accelerator+ X before applying.;
Danger May cause allergy or asthma symptoms or breathing difficulties if
inhaled. May cause respiratory irritation. May cause damage to organs through
prolonged or repeated exposure. Contains isocyanates. May produce an allergic
reaction. If medical advice is needed, have product container or label at
hand. Keep out of reach of children. Use only outdoors or in a well-ventilated
area. IF INHALED: Remove person to fresh air and keep comfortable for
breathing. If experiencing respiratory symptoms:
Call a doctor. Dispose of contents/container to a licensed waste disposal
facility.
Supplementary information
Persons already sensitized to diisocyanatos may develop allergic reactions when using this product. Personssuffering from asthma, eczema or skin problems should avoid contact, including dermal contact, with this product. This product should not be used under conditions of poor ventilation unless a protective mask with an appropriate gasfitter (i.e. type A1 according to standard EN 14387) is used. Contains: Reactionmass of xylene and ethylbenzene diphenylmethane-4,4’-diisocyanate.
outwell.com
Outwell® is a reg. trademark of Oase Outdoors
EU: Kornvej 9, DK-7323 Give, Denmark
UK: One Glass Wharf, Bristol, BS2 0ZX
© 12/2022 Oase Outdoors ApS.
Packaged in the EU
with components from
EU and Taiwan by
Gear Aid®/McNett Europe.
© 12/2022 Oase Outdoors ApS.
MORE TIPS + INFORMATION ON WWW.GEARAID.EU AND
OUTWELL.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>