SKIG SJR343 Third Mock Examination Wireless Mouse Instruction Manual
- October 30, 2023
- SKIG
Table of Contents
SJR343 Third Mock Examination Wireless Mouse
Instruction Manual
Program features:
- Bluetooth 5.0+3.0+2.4G the third mock examination SOC
- Extremely low power consumption (Tx=5mA), extremely high sensitivity (-96dbm)
- Good Bluetooth compatibility and fast reconnection speed
- Intelligent multi-level power saving, working distance greater than 10 meters
- Bluetooth supports multi-channel, can connect multiple devices, and switch freely
- Built-in boost (adjustable from 2.2 to 2.8V), simple peripheral components (about 20 in total)
- Provide code free testing dongle, Bluetooth device name modification dongle
- Support for keyboard and mouse sets
- Supports Windows Bluetooth fast pairing of Swift pair and mouse power display
- Bluetooth chip has passed BQB 5.0 certification, QDID=115877
Hardware specifications
Chip: BK3632 QFN32/BK2451 QFN20
Sensor:
Pixar: 3205/3212/3065/3065XY/3220
Key/LED:
7Key: Left/Middle/Right/4/5/DPI/Pairing + Bluetooth/2.4G mode switch key
3LED: 3 channel indications, wired/paired/reconnected/low voltage/low voltage
shutdown
Special instructions
- Default Bluetooth device name: BT5.0 Mouse_ Pro/BT3.0 Mouse Supports up to 17 bytes (17 English letters or 5 Chinese characters)
- 4G is designed for matching codes, and must be paired and shipped before leaving the factory
- Report rate=90Hz in Bluetooth mode, and Report rate=250Hz in 2.4G mode
- After Bluetooth enters pairing mode, the computer will search for 2 Bluetooth device names (BT5.0/3.0 Mouse)
Suggest prioritizing BT5.0 Mouse pairing
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.